Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: Telemorris on November 29, 2010, 02:14:07 AM

Title: Cleaning reeds after tuning
Post by: Telemorris on November 29, 2010, 02:14:07 AM
I started tuning my Presswood Pokerwork yesterday. I've been using 220 wet or dry grit sandpaper and a piece of metal for backing. The sandpaper leaves a dust residue and I've been wondering about the best way to get rid of the metal and sandpaper grit. Probably best not to use a finger to wipe the reed as finger oils and such might cause rust later. Do I do something about the dust or just forget about it and hope the vibrations do the cleaning for me.
Title: Re: Cleaning reeds after tuning
Post by: Owen Woods on November 29, 2010, 02:39:14 AM
Could try using a camera lens blower? It depends how much the metal dust insists on sticking to the reed.
Title: Re: Cleaning reeds after tuning
Post by: Telemorris on November 29, 2010, 05:16:43 AM
I was thinking about one of those cans of compressed air to blow the metal dust out. Is there any need to worry about the dust getting embedded into the opening in the plate and causing blockage of the reed tongue, preventing proper movement of the tongue?
Title: Re: Cleaning reeds after tuning
Post by: Lester on November 29, 2010, 07:44:28 AM
What you need to do is "ping" the reed as you withdraw the shim that you are using to support the reed. This should dislodge any debris. If any remains I use a toothbrush to give the reed a quick clean.
Title: Re: Cleaning reeds after tuning
Post by: LJC on November 29, 2010, 08:33:18 AM
Give it a good play with the treble and bass grilles removed. This should blow any mess out of the reed block and off of the reeds and out of the box without it collecting up in the mesh. If I've been handling reeds I usual give them a wipe with whit spirit before I glue valves on. This helps to clean any old glue off and give a good clean surface for the new valve to bond to.

edit: Sorry, that reply is a little confusing - I am not saying clean and tune before valving, as of course you must tune after valves are in place, but the cleaning advice and principle is the same.
Title: Re: Cleaning reeds after tuning
Post by: blafleur on November 30, 2010, 11:46:39 AM
I keep a little piece of lint free cloth in my lap that I use for a quick swipe.  It can be real tempting to wipe with a finger, but don't.
Title: Re: Cleaning reeds after tuning
Post by: LJC on November 30, 2010, 12:17:55 PM
Old heavy cotton boxer shorts work great...  ::)
Title: Re: Cleaning reeds after tuning
Post by: Lester on November 30, 2010, 12:32:31 PM
Old heavy cotton boxer shorts work great...  ::)

Do you take them off first?
SimplePortal 2.3.5 © 2008-2012, SimplePortal