Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: Tamba on December 07, 2010, 08:55:06 PM
-
Hi,
I have got a problem with my Dino and could use some advice from those more experienced than myself. Over the past two weeks my Baffetti has developed a couple of sticky buttons on the right hand side (outside row), the construction is exactly the same as a carnival 2, i.e. buttons screwed onto a wooden lever that fits into a rebate with the spring trapped inbetween (apologies if this is unclear but those who have a box constructed in this way will know what I mean). The buttons stick down even when lightly touched and it feels as though the wooden lever is getting stuck in the rebate which it is meant to move freely within. The springs seem strong and spring back as expected once the stuck buttons are prised up a little. ??? I have had the grille off and can't spot any obvious problems in the area.
The first thing that I wondered is if this could be due to atmospheric conditions, the central heating has been on a lot over the past 2 weeks, and there is a constant stream of laundry drying in the house. At present I am reluctant to take out the long metal rod that holds all the bits in place in case the box just needs to be left to sort itself out as the central heating eventually gets used less. Has anyone else experienced a similar problem recently (or ever) and does anyone have any ideas about what they think the problem is and how best to remedy it. The box is made from maple I think (very pale/creamy wood),
thanks,
Tim,
-
It sounds exactly like the lever and/or the keyboard has swollen slightly and is sticking in the slot so it's more likely to be the laundry drying that's causing the problem. I'd personally stick it somewhere drier and see if it sorts itself out before doing anything to the lever.
Excessive central heating would have the opposite effect and cause the wooden parts to shrink slightly.
-
Hi Andy,
Yep. that is exactly what it feels like. I am going to move it to a laundry free zone (if I can find one!!) for a few days and see what happens. This is the first winter I have had this box (in fact, ever had a box of this construction type) so it is something I need to be aware of.
cheers,
Tim
-
Yes, I've had that happen with a Dino BP2 and a Castagnari Nik. With the Dino, I only had to dry it out a bit and rubbed candle wax on the sides of the levers - as used to be done to stop drawers sticking. The Castagnari was different as the length of the levers was a close fit and damp had made them elongate and stick, so I rubbed a little off the ends before waxing and reassembling.
Sadly, the open wooden type of action has to be disassembled slowly and carefully in situ, unlike a metal action that can simply be unscrewed. If it doesn't clear up just be keeping it away from humidity, then pull the pin - slowly!
Rob.
-
Thanks for the advice Rob,
I'm going to leave it a week or two in a dry place to see if it sorts itself out, and if not then it will be time to pull out the long rod and watch those levers jump!! ::) It's comforting to know that I'm not the only one to experience this problem.
cheers,
Tim
-
Hi,
In modern houses that are sealed etc moisture trapped in the house is going to cause a problem,even old houses that have increased loft insulation,double glazing,cavity wall insulation will have problems,eg in my mothers house a dehumidifier has to be used nearly constantly.
houses must breath.
Pete
-
Thanks Pete,
would taping one of those sachets of silica gel somewhere inside the box make any difference or would this be the most ridiculous suggestion that anyone has ever made!?
cheers :|glug
Tim
-
3 days shut in its box with a couple of sachets of silica gel and all is sorted, lesson learned! ::)
Thanks for all the advice,
Tim :||:
-
Hi,
Don't forget to dry out the silica gel.
Pete