Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: Steve C. on December 30, 2010, 01:50:53 AM

Title: Pokerwork thumbstrap-ectomy
Post by: Steve C. on December 30, 2010, 01:50:53 AM
Any thought on the best way to remove the treble thumbstrap? 
Would like a nice clean result.
(why I am I doing this after 35 years?  just got a new set of straps, nice italcinte's, now the old leather thumb strap looks crappy)
Thanks and regards, steve
Title: Re: Pokerwork thumbstrap-ectomy
Post by: Lester on December 30, 2010, 09:03:12 AM
Remove the keyboard and drill out the rivets from the inside.
Title: Re: Pokerwork thumbstrap-ectomy
Post by: Steve C. on December 30, 2010, 01:50:26 PM
Thanks Lester--what do you recommend to best fill the holes?

I have seen the posts regarding removal of the keyboard.  Is this as easy as it sounds?  What is the most likely screw-up?
Title: Re: Pokerwork thumbstrap-ectomy
Post by: Lester on December 30, 2010, 02:33:40 PM
Thanks Lester--what do you recommend to best fill the holes?

I have seen the posts regarding removal of the keyboard.  Is this as easy as it sounds?  What is the most likely screw-up?

I usually fill the hooks with air  ;D

Most usual screw up I have found is (assuming plastic fingerboard) when putting it back on it is possible to shear the bolts by over tightening them  :o
Title: Re: Pokerwork thumbstrap-ectomy
Post by: Bill the Farmer on December 31, 2010, 11:05:10 AM
The spare plastic plugs that come with kitchen units to fill the extra shelf holes fit exactly so you can't see daylight through the keyboard  ;D
SimplePortal 2.3.5 © 2008-2012, SimplePortal