Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: derekh on April 02, 2011, 05:49:35 PM

Title: reed blocks
Post by: derekh on April 02, 2011, 05:49:35 PM
im looking for d/g reed blocks for an old honher  any advice welcome or would d/g reeds fit into c/c# reed blocks without to much alteration
Title: Re: reed blocks
Post by: george garside on April 02, 2011, 06:50:44 PM
can't see any reason why they shouldn't -  provided you don't tell the reed blocks they won't mind!
Title: Re: reed blocks
Post by: Theo on April 02, 2011, 07:06:10 PM
It depends a bit on the age of the box, and the age of the blocks.   They are substantially the same but with a few small differences which could give you a little work.

1 Older Hohners have the gasket on the base of the reedblock, newer blocks don't have a gasket so you would have to fit a one.
2 Hohner have used several different designs of retaining clamp.  The older type can be used with newer blocks but you may need to adjust the clamp to get a secure fit.  Older ones have a screw bent into the shape of in inverted L which holds on the highest part of the block.  Newer ones have a metal plate and screw which clamp lower down.  They can be interchanged if you are prepared to make a few minor alterations.
Title: Re: reed blocks
Post by: derekh on April 02, 2011, 08:18:56 PM
they are the original reed blocks so i shouldnt have to much trouble then are caganoni reeds ok?
Title: Re: reed blocks
Post by: Theo on April 02, 2011, 08:47:32 PM
It can be done - I play a Hohner with Cagnoni reeds.  Most Italian reeds are longer for the same note compared with Hohner reeds, so you will probably have to carve out some wood from the top edge of the reed chamber to allow clearance for the reed tongue and valve.  You may not need to do it for every reed.  But check every reed for clearance, and enlarge as necessary.
SimplePortal 2.3.5 © 2008-2012, SimplePortal