Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: Graham Spencer on August 06, 2011, 01:16:18 PM

Title: Hohner cabinet corners
Post by: Graham Spencer on August 06, 2011, 01:16:18 PM
OK, so I've got these nice shiny chrome corners on order from CGM to replace the rusty old ones on a pre-pokerwork 2915 (or is it 2815? I've seen them referred to as both).  Question is, how do I get the old ones off without wrecking the woodwork or the lacquer finish? Any suggestions?

Graham
Title: Re: Hohner cabinet corners
Post by: Theo on August 06, 2011, 02:17:45 PM
They "should" side off but if there is rust on the outside then there is probably more underneath which will make that difficult.  I've used a hacksaw to cut along the length of the corner piece then wangled the remains off with a flat blade to lever up the cut edges enough to grab them with a stout pair of pliers.  Be careful of slivers of wood breaking away from the outsde next to the metal.
Title: Re: Hohner cabinet corners
Post by: Graham Spencer on August 06, 2011, 03:00:10 PM
Thanks Theo - I thought they should slide off but they're VERY rusty and attempts to get them moving with a fine drift have failed completely. I like the hacksawing idea - I'll give that a try, though I think I might go for a piercing saw to minimise the risk to the woodwork. I'll report back on how I get on.

Cheers
Graham
Title: Re: Hohner cabinet corners
Post by: Graham Spencer on August 07, 2011, 10:14:36 AM
Thanks again Theo - first corner successfully removed; let's hope the remaining 7 go as well!  I did have a little wood break away, as the rust was very well advanced, but it was a clean split and I was able to rebuild the corner woodwork  easily. In the end I used a very fine slitting disc in a Dremel, and it only took a minute or two.

Cheers
Graham
SimplePortal 2.3.5 © 2008-2012, SimplePortal