Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: stevejay on September 22, 2011, 08:43:56 PM

Title: stuck key (button) on a pokerwork
Post by: stevejay on September 22, 2011, 08:43:56 PM
I'm going to open it up and see soon, but any caveats or words of advice? All was fine but now a button sticks after being depressed.

Thanks,

Steve

PS treble side
Title: Re: stuck key (button) on a pokerwork
Post by: Lester on September 22, 2011, 08:50:41 PM
If it's depressed it probably just needs counselling  ;D

But more sensibly, just remove the grille and you can see just about all the treble mechanism and should be able to diagnose the problem.
Title: Re: stuck key (button) on a pokerwork
Post by: Theo on September 22, 2011, 09:18:56 PM
Sometimes a button can move to the side and catch under the edge of the hole in the fingerboard. If it dies not spring up when tweaked back, then the spring may be broken.
Title: Re: stuck key (button) on a pokerwork
Post by: Christopher K. on September 22, 2011, 09:19:53 PM
The lever inside the keyboard cover might not be properly aligned with the hole where the button protrudes, so that the button sticks under the edge of the hole when it is depressed. Take off the grille and with a pair of needlenose pliers, give the lever arm a tweak to one side or the other to line it up correctly. It should go in and out of the hole in the keyboard cover without contacting the sides.
Title: Re: stuck key (button) on a pokerwork
Post by: stevejay on September 22, 2011, 09:30:49 PM
Thanks for all these quick replies! I will keep them in mind while I inspect.  Believe it is a lever issue at this point.
SimplePortal 2.3.5 © 2008-2012, SimplePortal