Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: WestOz on October 18, 2011, 09:12:38 AM

Title: Leaky Bellows -Hohner Preciosa
Post by: WestOz on October 18, 2011, 09:12:38 AM
Any tips on how to find minor air-loss in bellows? Alternatively, any tips on how to fix it, even if you can't find where the losses are occuring? I have replaced the seals where the bellows connect to the ends.
Title: Re: Leaky Bellows -Hohner Preciosa
Post by: Theo on October 18, 2011, 09:27:11 AM
Air leaks show themselves through bellows movement, but may be caused anywhere in the instrument.  So don't just suspect the bellows.  You have to become an air leak detective.  Use your ears to listen for leaks, use your skin to feel air escaping - moistened lips are the the most sensitive part of the body for this purpose.  Leaks can occur from bellows gasket, enlarged bellows pin holes, loose screw holes for bellows straps, Pallets not completely covering holes, pallets not lying flat. But on Preciosas with original pallet facing its very common for there to be numerous tiny leaks caused by the pallet wood being slightly distorted.  Very old bellows can also develop slightly porous gussetts, and even found on my 1930s Hohner that there are areas where the inner bellows folds are becoming porous, even though there is no visible split.
Title: Re: Leaky Bellows -Hohner Preciosa
Post by: Sandy on October 18, 2011, 09:57:41 AM
Shouldn't we expect a little air loss in an old Hohner. ??? My pressed wood loses a bit but doesn't really bother me.......or should it  ???
Thanks for pointing out all the leaky places though, it certainly sounds like it's not always obvious.

thanks
Sandy
 (:)
Title: Re: Leaky Bellows -Hohner Preciosa
Post by: Martyn on October 18, 2011, 12:25:16 PM
Any tips on how to find minor air-loss in bellows? Alternatively, any tips on how to fix it, even if you can't find where the losses are occuring? I have replaced the seals where the bellows connect to the ends.

If there are any minute holes in the bellows these can usually be found by shining a LED torch through from the inside. Looking particularly at the inner corners.

Martyn
Title: Re: Leaky Bellows -Hohner Preciosa
Post by: WestOz on October 19, 2011, 08:30:04 AM
Thanks, Theo and Martyn
I will follow your suggestions, and report  - Terry
Title: Re: Leaky Bellows -Hohner Preciosa
Post by: Gandy on October 31, 2011, 12:31:28 PM
If yours has the internal bellows lock, check round the release button on the underside.
Title: Re: Leaky Bellows -Hohner Preciosa
Post by: Telemorris on October 31, 2011, 04:10:57 PM
I need to replace the gasket that seals the bellows lock on my Preciosa. Not sure how to get the button off though.

Would the plastic button be glued on and therefore need heat from a soldering iron to unscrew it from the rod? What kind of glue was used to attach these buttons?

Thanks!
SimplePortal 2.3.5 © 2008-2012, SimplePortal