Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: docEdock on November 19, 2011, 12:35:15 PM

Title: Best Way to Release Reed Blocks on a Gaillard
Post by: docEdock on November 19, 2011, 12:35:15 PM
My -- new to me -- Gaillard's method for securing the reed blocks uses three screws: two on the reed block and one into the body. Is there a preferred method for releasing the pressure, like say loosening the two screws that secure the slider but not turning the third screw? If so, is it best to loosen the inner (closest to the middle of the reed block) or outer screw first?
Title: Re: Best Way to Release Reed Blocks on a Gaillard
Post by: Lester on November 19, 2011, 12:47:18 PM
My Tommy had the same fixings, I always slackened off the non-block screws first then the ones on the block sufficiently to be able to slde the clamp thus releasing the block. This seemed the most sensible way to me but can't work out why  ??? But it was successful.
Title: Re: Best Way to Release Reed Blocks on a Gaillard
Post by: Theo on November 19, 2011, 02:49:36 PM
You should not disturb the single screw, just the two that go into the block itself, then you don't disturb the tightness of the block when it is re-fitted.
Title: Re: Best Way to Release Reed Blocks on a Gaillard
Post by: docEdock on November 19, 2011, 05:41:02 PM
You should not disturb the single screw, just the two that go into the block itself, then you don't disturb the tightness of the block when it is re-fitted.

Thanks, makes sense.

My Tommy had the same fixings, I always slackened off the non-block screws first then the ones on the block sufficiently to be able to slde the clamp thus releasing the block. This seemed the most sensible way to me but can't work out why  ??? But it was successful.

Lester, I used that same approach and then wondered.
Doc
SimplePortal 2.3.5 © 2008-2012, SimplePortal