Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: Andy Simpson on November 24, 2011, 02:44:24 PM

Title: Bellows corners conundrum
Post by: Andy Simpson on November 24, 2011, 02:44:24 PM
I'm gritting my teeth and preparing to make new bellows for my Koch presswood and all the stuff arrived from CGM today.

Everything seems to be fine and raised no questions apart from the metal corners. They don't sit anywhere near squarely on the cardboard, (the angle is probably closer to 100 than 90 degrees), and give the choice of either sitting flush on one edge and standing proud by 5-6mm on the other or a 2.5-3mm gap on each side.

I ordered the card and everything else at the same time and gave the finished dimensions as well and I can't imagine Charlie knowingly sending incorrect corners so am I just being thick and missing something?, (will they fold inwards when pressed, etc?.).

Any insights greatly appreciated.
Title: Re: Bellows corners conundrum
Post by: Andy Simpson on November 24, 2011, 05:02:42 PM
Experimenting on the knackered original bellows, I can get the corners, (round Italian-style ones, not the square Hohner type), to seat properly by chamfering the corners of the cardboard. The rest of the cloth and the leather corner gussets still hold everything together and once the corner goes on with glue and another layer of cloth then it should be airtight. The bellows should function normally but this strikes me as a rather dubious and highly questionable method and it can't possibly be the proper way to do it...
Title: Re: Bellows corners conundrum
Post by: Martyn on November 24, 2011, 07:28:10 PM
If you have no joy bring them round one day next week and I'll have a look at them.   :-\

Martyn
Title: Re: Bellows corners conundrum
Post by: Andy Simpson on November 25, 2011, 12:29:20 AM
The more I think about it, the more I think it must be the only way but it still seems wrong somehow.

Snipping the point off the cardboard is the only way the corner will actually fit on, the shape of the inside simply can't mate properly with a 90 degree edge and if the angle is going to change when they're flattened by being pressed it'll be to a more obtuse angle if it's done too hard or with uneven pressure, causing them to splay outwards. It only leaves a tiny hole that's easily re-covered and the structural effect is negligible, especially once the corner is crimped on.

Every Italian box I've seen has bellows corners that are similarly rounded and there's no way they'd fit on bellows with perfect 90 degree corners. Once you have eliminated the impossible, whatever remains, however improbable....
Title: Re: Bellows corners conundrum
Post by: Mike Averill on November 25, 2011, 02:22:29 PM
Looking at my Sonola which has rounded bellows corners, one of which is missing the metal, the corner is chamfered off. There also appears to be linnen or similar fabric glued over the corner all the way round to keep the edges firmly together.
Title: Re: Bellows corners conundrum
Post by: Andy Simpson on November 28, 2011, 04:26:15 PM
Thank you!, that's really put my mind at rest.
SimplePortal 2.3.5 © 2008-2012, SimplePortal