Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: Ziachmusi/Louise on May 29, 2012, 11:52:53 AM

Title: Bellow corners
Post by: Ziachmusi/Louise on May 29, 2012, 11:52:53 AM
My C/F honey wood needs a new metal corner. I already have one but whats the best method of squeezing it when newly attached?
I think if I squeeze the bend then the straight bits might distort out wards it would no longer be 90°. So is there a trick or am I just being a bit of a wimp?

Louise
Title: Re: Bellow corners
Post by: Theo on May 29, 2012, 11:56:15 AM
It only needs to be squeezed very gently.  Put some pva inside it too which will also help to hold it in place.
Title: Re: Bellow corners
Post by: Ziachmusi/Louise on May 29, 2012, 11:57:17 AM
Thanks Theo You're a hero ;D
SimplePortal 2.3.5 © 2008-2012, SimplePortal