Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: palet trouble  (Read 1260 times)

0 Members and 1 Guest are viewing this topic.

hubert

  • Good talker
  • **
  • Offline Offline
  • Posts: 82
palet trouble
« on: December 24, 2013, 03:41:54 PM »

SOS.... I have run into trouble with my pokerwork bass, two buttons jammed, so I had a look,and found the push C and C chord pallats  had stuck one on top of the other, a bit of a push got them working again, then when I played B chord, the C chord started to jam again, I got them working again , playing nice for half an hour, then the B started sticking again, any ideas why this started out of the blue?, and what can I do about it?....Hubert
Logged

hubert

  • Good talker
  • **
  • Offline Offline
  • Posts: 82
palet trouble
« Reply #1 on: January 13, 2014, 12:37:19 PM »

SOS.... I have run into trouble with my pokerwork bass, two buttons jammed, so I had a look,and found the push C and C chord pallats  had stuck one on top of the other, a bit of a push got them working again, then when I played B chord, the C chord started to jam again, I got them working again , playing nice for half an hour, then the B started sticking again, any ideas why this started out of the blue?, and what can I do about it?...I posted this just before Christmas,has this baffled everone? surely not! ....Hubert.
Logged

malcolmbebb

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2628
  • In dampest Dorset, on the soggy south coast.
Re: palet trouble
« Reply #2 on: January 13, 2014, 12:45:22 PM »

Could you post a photo or two?
Logged
Dino BPII.
"Tradition is not the worship of ashes, but the preservation of fire."

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: palet trouble
« Reply #3 on: January 13, 2014, 01:28:07 PM »

I missed your previous post, probably to busy eating!

One cause of this can be that the pallets are able to move slightly along the arm, but there might be other reasons.  Because the chord pallets are trapezoidal a movement parallel to the arm can cause them to overlap.  The solution is to move them to the correct positions and then secure them in place, either with hot melt glue, or a small cloth patch glued on with pva.  It is best not to put glue in the slot in the pallet as it is then almost impossible to remove without damaging the wood.

Other things to check:
the screws holding the steel mechanism down are tight
no springs are broken
The axle rods are both in place and some sticking out each end
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal