I have a 21 button DDR two row. I've had it for 20 years or so. There's always been a problem with the pallets. These are raised with thin wire arms. They don't always land in the same place. Sometimes they leave a slight gap over the hole and occasionally one pallet will fall on top of another. In most instances a quick flick of the button removes the problem. I've noticed that the problem is more likely to occur when I am playing across the rows and certain chord combinations almost always cause problems. The pallets are small plastic pads with a push fit onto the arm. The wire arms are set into the wooden fingerboard where they pivot. Ive tried making slight adjustments to the pallets, sliding them up and down the wire arms - to no avail. There is some play at the pivot end, but nothing excessive. It is my opinion that the problem is the with the arms themselves, which are too flexible. A sharp tap on the button causes the arm to fly up, then vibrate from side to side before falling back into place, or not, as the case may be. Is there anything I can do to improve the action and prevent the pallets falling in the wrong place?