Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: 1 [2]   Go Down

Author Topic: Repairing Hohner woodwork  (Read 3471 times)

0 Members and 1 Guest are viewing this topic.

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Repairing Hohner woodwork
« Reply #20 on: September 16, 2015, 04:19:47 PM »

If you have depressions that are bruised rather than wear you can bring them back with steam. Place a damp cloth over the dents then apply a hot iron for a few seconds.  Inspect and repeat as required.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

robotmay

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 820
Re: Repairing Hohner woodwork
« Reply #21 on: September 16, 2015, 04:42:50 PM »

Ooh thanks for the tip; there is a bruise that might react to that. I was going to ignore it but that's worth a try anyway. Most of the damage to the finish is isolated to the back anyway. The front of each box just needs a bit of a polish to remove scratches and restore it a little, the top/bottom of the treble box needs stripping and re-finishing, and the back has a bruise and a separate gouge down to the wood I'd quite like to fill. I'll chuck some photos up in a couple of hours!

On the bright side I have some nice new fittings and straps I traded for with Emmanuel which should be rather nice than the originals (:)
Logged

robotmay

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 820
Re: Repairing Hohner woodwork
« Reply #22 on: September 16, 2015, 06:29:06 PM »

Here's the sunbleached (probably) front. I'll probably just go over this with the button polish, as I think it'll come up rather nice.



This is the bruise which I'll try your tip on Theo:



And here's the chip on the same part I mentioned before, which I'll try to blend by using the darker polish first, I think:



I've ordered myself some garnet shellac, which I'll try applying with a mop to the stripped panels once I've mixed it up. It doesn't need to get as dark as the original finish, just close enough to how that front panel looks, which I think it should do.
Logged

robotmay

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 820
Re: Repairing Hohner woodwork
« Reply #23 on: September 22, 2015, 11:29:35 PM »

Right, garnet is nowhere near the colour either. I've ordered some Van Dyck crystals and I'm going to experiment on some scrap wood to see if I can match the stain used on the box. Annoyingly, where I used masking tape to protect the better side of the box (the front, with the graphics), the polish soaked through the tape and lifted the finish and stain off that side too. So now I need to see if I can match and repair that, or figure out a way of stripping the finish from that panel without removing the graphics :-\
Logged
Pages: 1 [2]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal