My wife's concertina started to produce a single "ghost" note when various keys were depressed on one side, with the bellows on the pull.
On opening it up, I found that a valve had buckled slightly and the tip was getting caught in the end of the reed box chamber. The valve had been trimmed very short and at a slight angle and was not completely overlapping the end of the reed box chamber and was therefore catching inside the chamber and the reed was sounding from time to time.
I replaced the valve with a slightly longer version and the "ghost" note is no more.
On checking the rest I found that several valves had been cut so that they were only just resting on the end of their reed chambers, and several appear to have been deliberately trimmed at an angle so that they have left a minute triangle of the reed chamber not covered. There are no other "ghost" notes.
The question is: (and also thinking about my own melodeons)
Should the valve overlap the reed chamber by say, two to four mm all round to effectively seal the chamber, or is the above as described normal practice ?