Well, perhaps some exceptions. I’ll never run a marathon at my age, knees & hips dontcherknow. But I have just more or less successfully fettled my first box at the age of 70. It is a Hohner one row two stop in G.
It was leaking like a very coarse sieve. Many thanks to Lester and Theo who were both helpful in diagnosing and suggesting remedies. Also to CGM musical for supply of materials (leather for spoons, a replacement spoon, bellows gasket and felt/leather for the pallets). The original facings on the pallets and spoons were black felt, and clearly past their best.
I thought I would post some details of the process I used as I was improvising, and careful searches here failed to yield advice in these areas.
When I peeled the facings off the pallets there was a sticky black residue which was difficult to scrape off. White spirit was ineffective in dissolving it. Somewhere in the workshop there was a can of acetone, or possibly I finished it off. So I got a 500ml bottle from the local nail bar, a very reasonable £6 odd. A shallow saucer with a 3mm deep layer of the stuff in it proved effective in dissolution of this sticky layer so that it could be mostly scraped off with a Stanley knife blade. Once the pallets had dried off (almost immediately with acetone in the current heat) then the surfaces were sanded flat and clean with a piece of 335 U production paper laid on a flat wooden table. If you fold it in half the paper will grip the table sufficiently to sand the pallets level and smooth.
The acetone also degrades any traces of animal based glue in the grooves for the levers. Once this has dried the remnants come out pretty easily with a suitable length of piano wire or similar. To attach the felt I used 3m Photomount. I had an old tin of this kicking around. I’m guessing it is identical or very similar to their 77 spray adhesive, only in a smaller tin, and cheaper. Sprayed outside against newspaper on a windless dry day the collateral damage to the kitchen/workshop is eliminated. Which is good. Inside the stuff gets everywhere. It adheres pallet facings well, together with dust, filth, and anything else.
The pallets were then attached to the levers using hot melt glue. I ruled a faint pencil line on the box to ensure the pallets line up, as the open time with hot melt glue is fairly brief. Any slight unevenness of the buttons is easily remedied by judicious bending of the levers.
Reassembly of the keyboard was pretty straightforward. I used a glue which I have not seen mentioned here to improve the sealing around the various screws and bolts. It is called R/C Modellers Craft Glue. It dries clear to a rubbery flexible consistency. It is available from Deluxe Materials
www.deluxematerials.com in Hampshire. I ran it round the joints at both ends of the box where the original animal glue had crazed, as Lester advised me that this is a frequent cause of leaks. Also the washers and bolts to act as a sealant and to reduce the chance of loosening from vibration. I know from previous experience that the seal holds well, and is easily broken without damage to components.
The instrument is now as airtight as I think these things ever are, and sounds lovely. The remaining problem is the bellows are a bit stiff. I guess they’ll loosen up with use.