I'm working on an older, inexpensive PA which needed a tuning and several 'buzzing' notes remedied. From what I can tell, after a thorough examination of all other possible causes, it appears to be a case of a few loose reed tongues/rivets which was causing the buzzing. To test this, I took the reedplate out, gently tightened up the rivet with a pair of pliers squeezing them back together, and then re-installed. The problem was gone, although in one case it returned again. However, what I'm noticing is that some reed tongues are developing this problem as soon as I begin any tuning work on them. Is it possible that these reed tongues are already on the verge of being loose, and the process of tuning them disturbs them enough for some of them to begin to rattle? The tuning process is certainly not vigorous one - in this case it is just a few scratches towards the base of the reed to flatten pitch, but I've noticed in a few of them that they began to buzz immediately after I did this. Has anyone encountered this before?