Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: greasing wood?  (Read 591 times)

0 Members and 1 Guest are viewing this topic.

Stefan

  • Member
  • *
  • Offline Offline
  • Posts: 46
greasing wood?
« on: September 08, 2023, 07:07:56 AM »

on my bench is a lovely chromatic piano accordion. (Hohner imperial 4a).
The fulcrum of the keys, and of course the keys are made of wood wich leads to some friction.
I would like to prevent disasembling the keybed because only one or two keys are sluggish.
Wood sucks up humidity and can swell so i naturally will avoid liquid grease.
Any tips? Graphite? Wax?
Logged

Rog

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2525
  • Repair and tuning in Hants
Re: greasing wood?
« Reply #1 on: September 08, 2023, 07:22:33 AM »

You can try ptfe graphite spray. My experience of old keyboards with sticky keys is that they almost always need taking apart, esp if i'm sending it off to a customer, because the sticky key issue is likely to come back if you don't resolve the issue by cleaning and sometimes sanding. For a piano keyboard, the method that is sort of effective is to use a feeler gauge down between the keys, to try and clear any debris. And a piece of glass paper slotted into the gap. Otherwise the keys have to come off…if you can get the axle out. Sometimes you get lucky and the keys come off individually (heaven…). But…yours is a chromatic instrument and on many of these you have to remove the key tops to get the finger board off to get the keys off. To my shame i always turn away chromatic boxes with sticky keys for this reason. Allodi in London does a lot of them so i point people to him. I see about one or less a year so it's not something that i'm losing money over.

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: greasing wood?
« Reply #2 on: September 08, 2023, 08:59:29 AM »

I’ve repaired lots of diatonic boxes with sticking wooden keys, but I’ve never been fully successful without a complete strip down of the keyboard.  I’ve tried ptfe spray, and graphite.  If you do try these make sure that they don’t have an oily liquid carrier. I would avoid putting abrasive paper between the keys because there is a risk of leaving abrasive particles behind.
The cause is usually gritty dust that’s worked its way down to the axle, or sometimes corrosion of the axle.  The solution is to clean and polish the axle, remove any visible dirt from the sides of the keys, and clean out the holes in the keys taking extreme care not to enlarge the holes. I usually use a twist drill of the same diameter as the axle and use this, held in the fingers only, to ensure the holes are free of contamination.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Rog

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2525
  • Repair and tuning in Hants
Re: greasing wood?
« Reply #3 on: September 09, 2023, 08:15:17 AM »

One other suggestion...check on the Accordionists forum, because your main problem is how to successfully get the keys off and then back on again. Sometimes there is access through the back of the keyboard. But otherwise all the key tops have to come off, which is unlike most melodeons.
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal