Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: removing reed plates from reed blocks  (Read 318 times)

0 Members and 1 Guest are viewing this topic.

kenakordeon

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 264
removing reed plates from reed blocks
« on: June 11, 2025, 05:26:35 PM »

One row melodeon. Should I melt the wax holding the reed plates in place (my guess is to use a low wattage soldering iron with a pencil-type tip) or use an x-acto knife and cut the wax at the edges of the reed plates and then unscrew the screws at the tops of the plates and then pull away from the block? When the reed plates are waxed into place does some of the wax seep under the edges of the plate? Obviously, this will be the first time I attempt removing reed plates and I hope not to mess up too badly.

Thanks for any advice.

Ken
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: removing reed plates from reed blocks
« Reply #1 on: June 11, 2025, 05:52:49 PM »

Don't melt the wax before removing reeds.  That would just result in a sticky mess.  If there are screws as well as wax remove the screws first then use a blunt knife to lever the reed plate up out of the wax.  A blunt knife is better for this than a sharp one because it reduces the chance of removing wood along with the wax. I use an old broken kitchen knife with the broken end ground at a right angle.  It makes a good safe scraper that will remove wax easily.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

kenakordeon

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 264
Re: removing reed plates from reed blocks
« Reply #2 on: June 12, 2025, 12:47:58 PM »

Thank you for that instruction. That is how I will remove the plates.
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal