Two more Questions.
1) The first picture is of the bass reed block, the larger one. There are two large single reeds, from left to right, then a double reed. The left reed is on the underside hence the leather valve on top. The second reed is on top so I thought there should be a leather valve on the underside, (see second picture), but there isn't. Should it be that way? Is it valveless so it works on push and pull? If it had come off it would have been loose under the block when I removed it. I'm sure the blocks were never removed since it was built, at least there is no evidence of them having been removed.
2) The third picture is of the board the treble end reed block is glued to, the fourth picture is of the reed block with the reeds still in it. If you look close you can see the shine of the old hide glue on the board, it is around the perimeter and all around the round holes. Is it necessary to glue it back on as it was (around the round holes) or will just gluing around the perimeter suffice?
Also the reed block was nailed with small brads from outside of board into the block at each corner. I'm wondering if anything at all is necessary. All the brads are going to do now is to act as locators and not really have any holding power. I'm thinking bolts would be good if it ever had to be remove but then you would need to use gaskets and that would raise the block, and the slide for the stop would be too thin.
Thanks to all, Tom