Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Removing the Face Plate on a Concertone Melodeon  (Read 382 times)

0 Members and 1 Guest are viewing this topic.

Richard Friedman

  • New Starter
  • Offline Offline
  • Posts: 3
Removing the Face Plate on a Concertone Melodeon
« on: December 16, 2022, 08:45:37 PM »

The attached image shows the face plate (that's what I call it) of my Concertone.  I have removed the 4 corner screws but it seems to be attached in the horizontal (of the picture) middle on both sides, by some invisible means.  I need to remove it in order to get to the back side of the hardware that is holding the strap.  I am guessing that it is glued, but before applying any methods to break the bond, I though I would create this posting.  In addition on the opposite side from the glued joint, there are two nail points sticking out which were penetrating the bellows housing.  These nails are loose to wiggle, and I expect the face was off when the nails were driven in.

Do I proceed to break the bond?

Your comments are appreciated
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Removing the Face Plate on a Concertone Melodeon
« Reply #1 on: December 16, 2022, 09:07:44 PM »

Possibly some of the screws that hold the clamping contraptions may be penetrating to the edge of the cove
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal