Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Tiny Hohner Questions  (Read 3821 times)

0 Members and 1 Guest are viewing this topic.

RGF

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 214
Tiny Hohner Questions
« on: February 03, 2012, 05:49:10 PM »

I've recently picked up at ebay this very tiny Hohner PA.....12-bass, 25-key, 2-reed MM on the treble side. Is this a Presciosa? A Regina? Or what? I've searched here but not found a definitive answer. I'd sort of concluded that it was a Regina, but they read your comment, Theo, that you had a 3-reed Regina that looked like this one. There's no evidence of any model name on the instrument.

But, on to the Construction & Repair bits ------

Waxing. These narrlow little reeds are so very close together that even if I could fit a thin blade between them, the wax seeping down would surely catch the top edge of the plates and run out of control. I'm thinking that they need to be installed and waxed sequentially, i.e. waxing one on top, bottom, and first edge. Then wax the leading edge and quickly place the next reed into the soft wax, and proceed in that fashion. Perhaps also using Charlie Marshall's suggestion to place that wax with a brush, rather than a hot pen and wax stick, so one hand can be at ready to immediately place the next reed? Other suggestions?

And tuning. The bass reed blocks and the removeable treble reed pan don't appear as though they'll present any fresh problems. But what about the reed pan that's fixed into the treble side? It's only about 7mm deep, and even if I could get a lifter hook behind the inner reed tongue and support it, there's almost no room to bring a file to the reed tip. This reminds me of tryng to reach the starter on that early Renault 5 I once owned!

Experience is what you have just after you need it!

Thanks,
Bob

Logged

RGF

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 214
Re: Tiny Hohner Questions
« Reply #1 on: February 03, 2012, 05:56:17 PM »

Doh!....I forgot to attach this photo.
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Tiny Hohner Questions
« Reply #2 on: February 03, 2012, 06:18:24 PM »

It's a Regina I.  The Regina name was used on a variety of Hohner PAs,  all very compact compared with instruments with the same number of keys.  

"History Unfolds" lists:
Regina 1 25 key 12 bass
And then in increasing size Regina III, IV, V, VB, and V(B)(C) the last being a 41key 120bass 4 voice.

Tuning the lower layer of treble reeds is a bit of a nightmare.  The best I have come up with is to tune the reeds slightly on the sharp side, so once they are waxed in they only have to be tuned down which you can do with a scratcher without having to lift the tips of any reeds.

You seem to be thinking on the right lines with waxing.
« Last Edit: February 03, 2012, 06:22:32 PM by Theo »
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Owen Woods

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3894
  • melodeonmusic.com
    • The website and blog of Owen Woods
Re: Tiny Hohner Questions
« Reply #3 on: February 03, 2012, 06:19:09 PM »

That looks very much like a Regina. If it has flat mounted reeds in a flying pan then it definitely is! I don't know of any other Hohner instruments with that reed configuration.

I've always used the technique that you describe. It works, but I've been a bit concerned about whether it has actually sealed properly. If you heat up the wax slightly more than you otherwise would then it's viscosity will decrease, meaning that it would seep down easier - otherwise it tends to bead on the top of the crack. Don't heat it up too much though or bad things will happen.
Logged
Bergflodt D/G 4 voice, Saltarelle Bouebe D/G, Super Preciosa D/Em, Hohner Impiliput B/C+C#

Latest blog post: In Any Weather

http://melodeonmusic.com/blog

RGF

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 214
Re: Tiny Hohner Questions
« Reply #4 on: February 03, 2012, 07:22:14 PM »

Thanks for the replies. This really is a great community of most helpful (and interesting) people.

I'll be restoring this instrument for the newest member of our extended family, a great-nephew born in Chattanooga, Tennessee, last September. And while I know it will be a number of years before he's able to appreciate it, my hope is that his mom & dad (who seem to have leanings towards "back porch music") will have a go at it in the interim.

When it's all finished, I'll post a link to a photo album of the proceedings, should anyone be interested.

Bob
Logged

tedrick

  • Guest
Re: Tiny Hohner Questions
« Reply #5 on: February 03, 2012, 10:45:04 PM »

Looks like a fun project Bob! Would be a perfect box for bringing on the boat too!
R
Logged

RGF

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 214
Re: Tiny Hohner Questions
« Reply #6 on: February 03, 2012, 11:09:35 PM »

Reed,

I prefer a rather larger accordion, with larger bellows, for use on the boat.....as it otherwise has no built-in flotation.

Bob
Logged

Telemorris

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 405
  • C/F Preciosa
Re: Tiny Hohner Questions
« Reply #7 on: February 03, 2012, 11:18:52 PM »

I just recently waxed the reeds into my Hohner Preciosa, another one of those instruments where the reed plates touch each other. I ended up starting at one end of a row of reeds and waxing the outside edge. I then took the next reed in line, placed it next to the plate that was tacked in on the opposite side with about 2 -4mm of space between the two. I've been using a traditional metal "spoon" or knife to wax with lately and was able to fairly accurately get just a thin line of wax in between the two reeds. Then I'd immediately slide the next reed into place as the wax was cooling. There was a small amount of wax that pushed out of the joint. I'm fairly pleased with the result.

It does make a difference in how well the next reed is waxed in if it's sitting on the reedblock ready to slide into place. I found that I could get some wax on the mating edges of both plates if I spaced the two reeds with the right amount of gap.

Logged
Ed Stevens
Bridgetown Morris Men
Portland, Oregon, US
Erica D/G, Presswood Pokerwork G/C, Preciosa C/F

RGF

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 214
Re: Tiny Hohner Questions
« Reply #8 on: February 03, 2012, 11:40:45 PM »

Ahh, thanks.......that sounds like a very useful suggestion. I'll give it a try.

Bob
Logged

RGF

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 214
Re: Tiny Hohner Questions
« Reply #9 on: February 27, 2012, 01:18:03 AM »

So, I'm nearing the point of waxing the reeds back into this wee little PA, and I have a few more questions.

The treble reeds are installed flat in the instrument -- one set in a fixed 'pan' that is built into the case, and another reed pan stacked above it which is removeable via a couple of screws. The six smallest chambers in that removeable pan have had their volume decreased via the inclusion of some small wooden wedges, which are glued into the top end, opposite the air hole. They reduce the depth of the chambers at that point to just about 2.5mm. Need I have any concern about interference between valves & rear chamber wall at that point? Would there be any benefit (or harm) in turning that handful of reeds end-for-end to place the moving end of the reed at the deeper, bottom end of the chamber? Or should the valves just be left off those six highest reeds altogether? (Before you ask, I will admit to not having taken note of the way this bit was all put together before I went at it with the wrecking tools. Duh!  :-[)

And the other curiosity is that the six corresponding chambers in the lower, or fixed, reedpan do not have these little wedges glued into the cavities. Why would the be deemed necessary for one set of reeds and not the other?

Thanks!
Bob

Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Tiny Hohner Questions
« Reply #10 on: February 27, 2012, 08:02:32 AM »

Would there be any benefit (or harm) in turning that handful of reeds end-for-end to place the moving end of the reed at the deeper, bottom end of the chamber?

Put them in the same way round they were originally.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

RGF

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 214
Re: Tiny Hohner Questions
« Reply #11 on: February 27, 2012, 01:54:29 PM »

>>>(Before you ask, I will admit to not having taken note of the way this bit was all put together before I went at it with the wrecking tools. Duh!   :-[)

I really do wish I'd paid some attention to that! What was I thinking?.....or not. I didnt' even note if the highest few reeds had valves or not. Above which pitch, most typically, are the valves not deemed necessary?

Bob
« Last Edit: February 27, 2012, 02:01:04 PM by RGF »
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Tiny Hohner Questions
« Reply #12 on: February 27, 2012, 01:58:56 PM »

Haha ;D ;D First rule of taking apart - make a note of where things belong, or take photos. ;)

You can sometimes tell from the marks that the wax leaves on the reedplate which way round they were fixed.  If one end is up against a raised edge the wax laps over onto the top surface of the plate.

I have a Regina 1 downstairs that I'll look at for you later this afternoon.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

RGF

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 214
Re: Tiny Hohner Questions
« Reply #13 on: February 27, 2012, 03:03:55 PM »

>>First rule of taking apart - make a note of where things belong, or take photos.

Ah, yes, don't I usually. But then I fell into the situation of the amateur who thinks he knows a little bit more than he actually does, and feels safe, now, to take the occasional shortcut, leaving no trail of breadcrumbs. And of course it's involving an instrument model which I've never seen before.   ::)

It's a situation where I could likely noodle out the proper solution through trial & error, but when there's this vast trove of knowledge and experience here at Melnet....... (:)

Bob
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Tiny Hohner Questions
« Reply #14 on: February 27, 2012, 03:18:57 PM »

I've just looked at an unrestored Regina 1.   On the removable reed pan the top 3 plates on each bank are reversed.  The lower layer none are reversed.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

RGF

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 214
Re: Tiny Hohner Questions
« Reply #15 on: February 27, 2012, 04:36:27 PM »

Thank you, Theo!

That's what I thought might have been the case, as there are no "filler" blocks in the lower pan to cause potential interference.
But I wonder why it's put together that way, i.e. differently in the top & bottom pans.

Once again I say what a great place this is!

Bob
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Tiny Hohner Questions
« Reply #16 on: February 27, 2012, 04:44:16 PM »

It might be done that way so that the lower reed tips are more accessible for tuning, but you have to be ingenious to do it.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

RGF

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 214
Re: Tiny Hohner Questions
« Reply #17 on: February 27, 2012, 07:46:42 PM »

>>>but you have to be ingenious to do it.

There's the rub!
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal