Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: 1 [2]   Go Down

Author Topic: Glue for leather valves onto metal?  (Read 5737 times)

0 Members and 1 Guest are viewing this topic.

Garry Probert

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 296
Re: Glue for leather valves onto metal?
« Reply #20 on: February 20, 2017, 09:02:40 AM »

Hi
Quote
I've never used hide glue for valves, but my instinctive feeling is that it would set too hard/brittle which might be a problem with vinyl valves.
give it a try ,i've used hide glue for over thirty years but never used it on plastic but seems to stick perfectly,i think because its quick tack and effectively dehydrates to stick it has many more uses than i thought

I have to hard felt some new cornet valves i,m going to try the bottom layer with hide as an alternative to pva ,its so cheap and easy to use and readily available, and also so easy to remove and " i like the smell" lol
 
Logged

Kimric Smythe

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 712
    • Smythe's Accordion Center
Re: Glue for leather valves onto metal?
« Reply #21 on: February 20, 2017, 09:29:39 PM »

I use Pliobond here in the US it is low VOC so not to bad on the fumes. Smells a bit like cat pee.
 You just want to be careful and use a very thin layer as it will sometimes cause a single ply valve to warp.

In this case I apply the glue to the valve press it in place ,pull it off ,blow on it then stick it down.

http://www.hannarubbercompany.com/adhesives/pliobond/
Logged
Smythe's Accordion Center
Pinole, California
Sales and repairs since 1997
Pages: 1 [2]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal