The bass mechanisms (2 x 8 = 16 basses) from Hohner finally arrived (a large picture, nees zooming):
http://www.kolumbus.fi/slowsession/Morgane/Erica_bassmechanisms.jpg
This is just the start and it certainly will not be a small or easy job. Before I do anything I need to decide whether to make it a melody bass system or single basses with corresponding 5th chords arranged as Stradella or some other way. I have two sets of new unisonoric bass reeds in one octave from D to D but probably I will be needing more reeds. New reed blocks are required in any case. I have planned to use balsa wood for these as I read an article by Peter Hyde about using of balsa wood.
EDIT TO ADD: The next step I'm taking is to model all these parts and the Morgane bass end in detail with 3D CAD to see how everything fits and to make necessary drawings for parts needed to be made or modified.
---
After Lars wondered about the Erica C#/D reeds fitting the Morgne blocks I asked this from Hohner and the production manager himself promised to order (!?!) standard Morgane reed blocks to check if the Erica reeds will fit in them. Will take at least a month to get more information.
G'day Mates
This could be a dog’s breakfast as I'm not used to navigating around this site.
In regards to the balsa wood reed blocks that has turned up in discussion, I have been using it for many years with fantastic results. I know this at first might sound a little silly but it is stable and does not interrupt or absorb the resonation set up in the cavity. At this point you need a timber that does not respond to frequencies as you want as much as you possible can get to pass out off the accordion. My research has found in the last few years is that the timber of the accordion instrument needs to be inert, completely different to the guitar or violin type instruments. I have had a fantastic sounding piano accordion into my workshop for repairs that had Masonite (hardboard) sound boards, or should I say "dead boards."
In my last batch of acoustic boxes I put it all to the test, and made a box that was made from 90% foam, then testing with a frequency analyzer we found that we got a 33% increase in the lower partials and then it reduced to about 10-15% increase across the board in all the odd numbers with no increase in the evens. When I first played the box I thought I’d lost my top end as is sounded so low.
And by the way it is very loud!
Although I made this box about 6 months ago this is the first time I have posted anywhere that I have done this, although my friend/customer base know about it, and a few have tested it. I will have it at the National Folk Festival and Port Fairy Folk Festivals here in Aus’ over the next month or so.
My mate who analyzes my instruments who is himself a top shelf instrument maker suggested it might be better to make accordions and concertinas from MDF! I do not have time to test that one, but it might be worth testing by someone.
Back to work, and Good Health To You All.
Stormy
PS if you are searching for good Balsa wood then look in the yellow pages under Balsa Wood, as it is used by architects and theater set makers (and surf board makers here in Aus') and the darker harder stuff is cheaper as the trades want white balsa. You will find it far cheaper than the craft shop.