Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Tuning conundrum  (Read 4210 times)

0 Members and 1 Guest are viewing this topic.

Stiamh

  • Old grey C#/D pest
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3611
    • Packie Manus Byrne
Tuning conundrum
« on: January 21, 2008, 10:13:47 PM »

On the old board there were a number of topics discussing fine points of tuning, from which I gleaned that if you tune two voices of an accordion to a constant rate of Hz, the tremolo will increase as you go up the scale.

For example, if you tune the A of one voice at 440 Hz and the other at 442, when you get to A' the frequencies will be 880 and 884, which (unless I've remembered this wrong) means that the tremolo will be twice as fast - twice as many beats per second.

So therefore if you want a constant rate of tremolo, you adjust the gap, narrowing it as you go up the scale. Say keeping one voice at A=440Hz but letting the other get closer to A=440 as you go up. Am I right so far?

Now what happens when you have a multi-voice box in which all the voices can be turned on and off individually? Presumably you cannot proceed in this way because if you did, it would be possible to isolate a voice in which the octaves would not be in tune. Which would condemn you to having increasing tremolo as you go up... Or would the octave clash be insignificant at low degrees of wetness?

TomB-R

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 598
Re: Tuning conundrum
« Reply #1 on: January 21, 2008, 11:34:24 PM »

Wouldn't there be one "in tune" voice that you'd always use solo?  On my three voice box the registers give you no choice as to which of the tremolo reeds you use on its own.  If the registers allow you to isolate the others, isn't that a bit of a false option, "features" rather than "benefits"?
Logged

BruceHenderson

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 262
Re: Tuning conundrum
« Reply #2 on: January 22, 2008, 01:45:16 AM »

   Steve, the short answer is yes, but in some ways it works in your favor.  Nearly ten years ago, Normand Miron sat down with me and described his tuning system to me.  Basically, he told me that he felt that if you have a reed reed pair at 440 and 444, you're ear doesn't hear "440 plus a tremulo at 444" -- it hears a tremulo tone at about 442.  He said that he liked the "wetness" that you'll find if you set one reed at 440-3 or 4 cents and the other at 440+ 4 or 5 cents.  Then you set your bassoon at 220 and your piccolo at 880.  What your ear hears is a tremulo at 440 in octave tune with the high and low reeds.  I didn't understand it but in another discussion group, I found out that other tuners and musicians like this.  I ordered a 4-reed one-row from Louisiana tuned this way and *loved* it.  Further discussions led me to understand that other people like this tuning, too.
   You can't take out a middle reed and have it "dry".  If you try, your ear hears the high/low reeds at an octave to 440 and whichever middle reed you are using -- since that reed is off 440, the resulting tones will still sound wet.  But that's OK, it's much more important to have the three octaves in tune.  And this tuning sounds wonderful.
   You have to use the above tremulo to set the "bear rate" at A=440; once you've done this, you set your middle reeds for higher and lower tunes to the same beat rate.  For Quebec music, you need to temper to sound good with a piano.
   I like it. 
Logged
I love one-rows!  Four reeds kick butt!!!!

Stiamh

  • Old grey C#/D pest
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3611
    • Packie Manus Byrne
Re: Tuning conundrum
« Reply #3 on: January 23, 2008, 03:09:15 PM »

I should have made it clear that I was thinking about a box like my own - a three-voice MMM where you can turn each individual voice on and off. This means I can get a choice of four different sounds (three voices together, and three different combinations of two voices, which gives me three different varieties of swing).

Too many choices? Maybe, but I do like to have them available. Anyhow that's how my box is built, and quite a few others too. So I wouldn't call it a false option.

I'm pretty sure this is what my tuner has done - i.e. kept the octaves constant in each voice, which means that the tremolo increases at the top end. I'm happy enough with the sound but would sometimes like a bit more of a wobble in the lower reaches. Hence my question.

I was hoping Theo or other people who do their own tuning would say how they would approach such a project - i.e. setting the tremolo on a MMM box on which the voices could be controlled individually. I'll have to ask Normand next time I see him, Bruce!


Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Tuning conundrum
« Reply #4 on: January 23, 2008, 03:42:12 PM »

Hi Steve

There are so many possible ways to approach the tuning of a MMM box.  Apart from the usual spectrum from wet to dry, there is also the possibility of having unequal differences between the reed banks eg -3Hz 0 +5Hz or some such, as well as how the tremolo varies up and down the treble range. 

Since you already have a box with three stops you can perhaps give an answer to your own question based on your own experience.  If you just play with the + reed are you aware of out of tune octaves?  My expectation would be that if you listen carefully to octaves on the + reeds you might hear a beat, but in regular playing you might not notice.  I'd have thought that a bigger problem would be that you would be out of tune with everybody else across the range.

For what its worth when I'm tuning I don't tune to a constant Hz difference across the range.  I don't go as far as tuning for a constant beat rate either, though I do that on request.  I tend to go between those two so that for the lower two thirds or so of the range I'll use a constant difference in Hz  and then taper off the difference over the upper range.  I don't measure this tapering off, I just do what sounds right to my ear.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Lars

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 797
Re: Tuning conundrum
« Reply #5 on: January 23, 2008, 10:15:41 PM »

I've tuned one 2-voice and one 3-voice in my time, and both by ear to a medium swing sound. Afterwards, when checking against a tuner, the hZ-diff. was greater in the lower octave. As theo says, do what sounds right.

And then there's the evergoing "constant hZ" vs "constant Cent" question... I must say, I prefer the sound of constant cents with a slight taper off at the end, and this is to my knowledge the most common procedure.

//Lars
Logged

an bosca ceoil

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 347
Re: Tuning conundrum
« Reply #6 on: January 23, 2008, 11:17:54 PM »

0 I tend to go between those two so that for the lower two thirds or so of the range I'll use a constant difference in Hz  and then taper off the difference over the upper range.  I don't measure this tapering off, I just do what sounds right to my ear.

Theo,
This bit made sense, I was thinking it would be difficult to measure the taper when Steve talked about +2 as a starting point!!
Please enlighten me so that I can understand the rest of a topic like this!
(Initially I thought that that an instrument with 16ft row was the subject of discussion and so , I think did B. Henderson? Then it occurred to me that it might the higher octave/range of the row that was being referred to?)
Will you tell me the "correct" terminology for (a)The voice that is nowadays set at concert pitch ( "bear??" or was the man saying "bare") (b) The voices above/below, and explain the abbreviation MMM ( if it does have a low octave voice, would that be LMM?)
Going back to the talk of A` being 880 (surely A``) does that imply that old Hohners with the blocks stamped 870 were initially tuned to 435?
Regards ,
Bruce
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Tuning conundrum
« Reply #7 on: January 24, 2008, 08:53:05 AM »

Will you tell me the "correct" terminology for (a)The voice that is nowadays set at concert pitch ( "bear??" or was the man saying "bare") (b) The voices above/below, and explain the abbreviation MMM ( if it does have a low octave voice, would that be LMM?)
Going back to the talk of A` being 880 (surely A``) does that imply that old Hohners with the blocks stamped 870 were initially tuned to 435?

I don't think there is such a thing as "correct" terminology here.  Who says what is correct anyway.  There are several different sets of terminology in common use, and different people use different words.  It's unfortunate and can be confusing, and unless we have an international body governing reed makers and tuners then I can't see it changing.

When I describe the sets of reeds in the treble/right side I use the letter L M H to denote the low middle and high sets that are spaced an octave apart.  For example LMM  is a three voice with two middle sets of reeds and one set an octave lower. 

I also understand Hohner blocks stamped 870 to be tuned to what we would now refer to as A=435
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal