Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: 1 [2]   Go Down

Author Topic: Tremolo - constant offset VS constant beat frequency VS "tuning on the curve"  (Read 4128 times)

0 Members and 1 Guest are viewing this topic.

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping

...I don't know if other fettlers have tried similar experiments, or their tapering is because of being drawn towards "traditional" detuning with slower tremolo on low notes and faster on high notes, either because they think this is best or it's what customers ask for -- can anyone comment on this?...

I usually use tuning curves either based on current Castagnari factory tuning or 1930s Hohner Club/Erika tuning. Both have a slowly increasing rate of tremolo as you go up the range. The Castagnari rate is approx 1 Hz to 2.5 Hz low to high; the Hohner about 1.5 Hz to 5 Hz low to high. Both work for me; I like the effect produced.

I did try your 4 Hz tremolo acrros the range on one box a few years ago. It was good for outdoor morris playing but I found it generally too much tremolo for my own personal liking for indoor use. But that's just my own preference.
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

Graham W

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 277


What I still don't entirely know is whether I might find a constant offset more or less pleasant than "on the curve" tuning, but I would be choosing the constant offset (or not) for slightly different reasons than you.


You sound to be interested in exploring the idea of a constant slow beat across the range, which is just not normally done - I doubt you’ll find an example to listen to online. In my (limited compared to others) experience, if you tune an instrument based initially around say a 1 beat per second  tremolo there comes a point as you go up the scale at which that beat sounds (to my ear, but I know I’m not alone) just ‘wrong’ and out of relation to the lower notes. If you then sharpen the M+ Reed fractionally and progressively there there comes a point at which it finds its voice and sweet spot,  and sounds ‘right’. And so on up the keyboard - at which point you’ll probably find it’s all in the kind of ranges that Steve Freereeder has suggested!  It’s all very subjective and according to personal taste but I think tuning conventions have arisen for good reason.


Anyway, if it’s something you really want to experience then trying to describe a tuning quality in words is never great, so in the interest of learning why not  ask your chosen tuner if they will initially tune it with a constant offset and see how you get on with it (and post an audio clip to demonstrate it).  If it’s not to your liking then it’s not a massive extra job for them to gently taper the tremolo up the instrument later.
Logged

Rog

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2525
  • Repair and tuning in Hants

On choosing an offset: On occasion I’ve opened a tone generator in two browser tabs and played around with pitch offset between two tones, just to get a general idea of how a particular tremolo offset sounds, vs the pitch. Plus Microbot's samples are v useful.
Tech note: the Benetoux book on tuning has a set of curve tables at the back. My personal favourite is what he calls 'Celeste’ (about 3.5 Hz at A=440), though the tables are shown in beats per minute  (:).
For wetter styles it’s possible to set up these curves in Dirk's tuner, which will show the BPS for a given note (it’s not so good with dry tuning). This can make tuning to a particular curve a bit quicker. However I tune a lot of PAs, which tend to have *lot* of notes...so I’ll take any help I can get  (:)

diatonix

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 622

The Hertz scale being an exponential function, a constant offset (in Cent) only works if it is close to zero. While there is always 100 Cent between semitones, no matter how high or low, the number of cycles between two neighboring semitones increases dramatically the higher up you get. While a 20 Cent offset for G3 (the lowest G in a GC box) with its relatively few beatings per second sounds perfectly ok, G5 at the other end of the keyboard with the same offset would sound horrible in comparison, because now it takes a lot more Hz  to get from G5 to G#5
« Last Edit: January 04, 2021, 09:57:49 PM by diatonix »
Logged

IanD

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1703
  • Too many melodeons...

The Hertz scale being an exponential function, a constant offset (in Cent) only works if it is close to zero. While there is always 100 Cent between semitones, no matter how high or low, the number of cycles between two neighboring semitones increases dramatically the higher up you get. While a 20 Cent offset for G3 (the lowest G in a GC box) with its relatively few beatings per second sounds perfectly ok, G5 on the other end of the keyboard with the same offset would sound horrible in comparison, because now it takes a lot more Hz  to get from G5 to G#5

Which was my point exactly, because of the way the ear works; for absolute pitch on a single voice cents/percent error is what we hear, for two-voice detuning we hear bps/Hz between the reeds.

This is very easy to prove; for high-pitched reeds or tones (where absolute pitch perception also becomes a bit less accurate) you can have two reeds each of which sounded separately doesn't sound out of tune because the pitch error in cents is small, but which when sounded together beat horribly because the pitch difference in Hz is large.

It's also one reason that it's harder to get a consistent slow beat rate between higher-pitched reeds when tuning, a given frequency error in cents/percentage is a bigger error in Hz -- and also the reeds are smaller, so removing a given amount of metal shifts the pitch by more.
Logged
Oakwood Model 4 D/G, Castagnari Dony D/G/#, Castagnari Tommy G/C, Baffetti Binci D/G, Hohner Preciosa D/G, Melos Bb/Eb, Lightwave SL5 and Kala California fretless basses

IanD

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1703
  • Too many melodeons...

...I don't know if other fettlers have tried similar experiments, or their tapering is because of being drawn towards "traditional" detuning with slower tremolo on low notes and faster on high notes, either because they think this is best or it's what customers ask for -- can anyone comment on this?...

I usually use tuning curves either based on current Castagnari factory tuning or 1930s Hohner Club/Erika tuning. Both have a slowly increasing rate of tremolo as you go up the range. The Castagnari rate is approx 1 Hz to 2.5 Hz low to high; the Hohner about 1.5 Hz to 5 Hz low to high. Both work for me; I like the effect produced.

I did try your 4 Hz tremolo acrros the range on one box a few years ago. It was good for outdoor morris playing but I found it generally too much tremolo for my own personal liking for indoor use. But that's just my own preference.

I also said that this is all a matter of preference, especially if "sound quality" (how much you like the sound) is the main criterion. It's also true that a 4Hz constant-offset tuning to get the "loudest" sound can be too "loud" for some circumstances, though it should be possible to play a high-quality box quietly if it's correctly set up. But again if you want the reeds to speak reliably and quickly and not "choke" when played hard outdoors they'll be set higher in the frames than a box optimised for quieter indoor playing, which means they won't respond as well when played quietly.

As usual, there's no such thing as a box which is optimised for every use case, you have to decide what you want to do with it, and this applies to tuning and fettling as well as buying the "best" box in the first place. The Dedic-tuned DG Baffetti Binci I use for Morris is really too loud and raucous and unsubtle for accompanying songs; my almost-dry-tuned GC Tommy is fantastic for singing to but couldn't fight its way out of a wet paper bag playing for dancing. Horses for courses...
Logged
Oakwood Model 4 D/G, Castagnari Dony D/G/#, Castagnari Tommy G/C, Baffetti Binci D/G, Hohner Preciosa D/G, Melos Bb/Eb, Lightwave SL5 and Kala California fretless basses

Kon

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 165

Graham, I think working with a professional tuner using audio files is the way to go on this - thank you! I'll have to decide what to ask for as a starting point and which direction to tweak it in subsequently, but either way I'll be hearing my box and deciding what I want it to sound like.

Thanks everybody for the replies!
Logged
GC Erica

dino.pafftti

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 464

Here's an example with my C/F 1930s Hohner which I had recently tuned to Viennese tuning according to the curve attached previously.
https://soundcloud.com/steve_freereeder/when-the-king-enjoys-his-own

excellent sound ,,,, I would like to ask if aluminum tile or zinc tile reed ??
Logged

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping

Here's an example with my C/F 1930s Hohner which I had recently tuned to Viennese tuning according to the curve attached previously.
https://soundcloud.com/steve_freereeder/when-the-king-enjoys-his-own

excellent sound ,,,, I would like to ask if aluminum tile or zinc tile reed ??
Steel reed tongues on zinc plates.
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

dino.pafftti

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 464

Here's an example with my C/F 1930s Hohner which I had recently tuned to Viennese tuning according to the curve attached previously.
https://soundcloud.com/steve_freereeder/when-the-king-enjoys-his-own

excellent sound ,,,, I would like to ask if aluminum tile or zinc tile reed ??
Steel reed tongues on zinc plates.

thanks (:)
Logged
Pages: 1 [2]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal