Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: 1 [2]   Go Down

Author Topic: Does waxing in reedplates affect pitch?  (Read 2726 times)

0 Members and 1 Guest are viewing this topic.

Arnold

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 711
Re: Does waxing in reedplates affect pitch?
« Reply #20 on: February 28, 2023, 05:27:01 PM »

Nice! What’s the cheapskate alternative?  ;D I’ve just made a scraper out of an old 1.4mm drill bit and electrician tape, so I know there’s probably one out there!..
Go to starbucks and half inch a load of coffee stirrers, pva some 400 grit abrasive paper to one end

A bit upmarket. It will have to be Wetherspoons where I’ll be less conspicuous  8)
Logged
Dancing about architecture since 1997

Winston Smith

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 4066
  • AKA Edward Jennings
    • "Our Luxor B&B" Luxor life, slice by slice.
Re: Does waxing in reedplates affect pitch?
« Reply #21 on: February 28, 2023, 06:00:54 PM »

"What’s the cheapskate alternative?"

A man after my own heart! Firstly, get a daughter with a beauty salon. Secondly, call in on the premise of just saying hello, and maybe grabbing a cup of tea or coffee. Third, on the way out, cadge a few nail buffing thingies! They're four sided quite firm foam, about 3/4" wide and maybe 3 1/2" or 4" long with abrasive (pretty fine, but I don't know the grade) on all four sides. I find these ideal for the front face of the reeds. (10 for £3.49)
https://www.ebay.co.uk/itm/174867972112?
Of course, you cannot fit them into the slots to do the back of the tongues. But I've found that usually I can get most of that off with a piece of wet and dry under the tongue or a small flat bladed screwdriver down the slot, and at the worst, a little strip of the wet and dry glued onto a divided up lolly stick. Although it seems to be quite common to pick these up from Starbucks or somewhere, I do prefer to get them via eBay where they can be had in different thicknesses and widths for not a lot of money.
« Last Edit: February 28, 2023, 07:16:59 PM by Winston Smith »
Logged
At last, broken and resigned to accept conformity.
Oh, how I LOVE Big Brother!

Arnold

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 711
Re: Does waxing in reedplates affect pitch?
« Reply #22 on: February 28, 2023, 06:03:27 PM »

Had a bit of a brainstorm walking home from work. Thank me later  ;D: Magic Eraser!

Skip to 4:40 for use to remove rust: https://m.youtube.com/watch?v=y4F200dfBE0
« Last Edit: February 28, 2023, 07:36:20 PM by Arnold »
Logged
Dancing about architecture since 1997

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Does waxing in reedplates affect pitch?
« Reply #23 on: February 28, 2023, 08:02:51 PM »

If you remember the ink rubber from distant schooldays they are good rust removers, or if you can't find one then a polishing block.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Arnold

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 711
Re: Does waxing in reedplates affect pitch?
« Reply #24 on: February 28, 2023, 08:19:11 PM »

Yep. On reflection perhaps the magic eraser isn’t quite the ticket since it leaves sponge dust everywhere. Perhaps prior to valving etc it might be good. But the job is done now at least!..
« Last Edit: February 28, 2023, 08:25:03 PM by Arnold »
Logged
Dancing about architecture since 1997

Rog

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2525
  • Repair and tuning in Hants
Re: Does waxing in reedplates affect pitch?
« Reply #25 on: March 01, 2023, 02:17:11 PM »

Abrasive rubber block is one way to clean reeds. Garryson (Garryflex) do them (120 grit) on eBay. Normally I get the little ones but the big ones can be cut up into eraser sized chunks (if you order the wrong size, as I did recently).
Pages: 1 [2]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal