Melodeon.net Forums
Discussions => Instrument Design, Construction and Repair => Topic started by: waltzman on November 18, 2009, 11:26:14 PM
-
So far I've been doing all my tuning 'in the box' without using a tuning table. I'm now trying to tune a stradella bass which I've never done before. Is there a relatively easy way to isolate a given reed on the chord reed block for tuning or do you have to use a tuning table?
Thanks,
Michael
-
Just tape over the air holes in the bass block for the reeds you want to silence. That way you just get the one note making it easy to identify and tune.
-
Just tape over the air holes in the bass block for the reeds you want to silence. That way you just get the one note making it easy to identify and tune.
That works, but you do spend a lot of time pulling reedblocks in and out.
Another approach is to take off the bass end cover and use an appropriate tool to reach under and behind the mechanism to open individual pallets. This will usually operate two reeds an octave apart, you might want to tape over the holes on one side of the block for this.
-
With a suitable bit of board with a hole in, you can use the instrument's own bellows as tuning bellows.
-
It can be hard to get proper access to the reeds and blocks with the bellows still attached. For regular melodeon basses I will cover all but one of the chord reeds for each button meaning I can tune part of each chord without taking the blocks out. Once one is done you can just shift the tape over. Taking them out isn't such a pain with the Hohner swivel friction clasps (apart from the sharp ends) but I would agree that its a pain having to grab a screw driver for every note!
-
With a suitable bit of board with a hole in, you can use the instrument's own bellows as tuning bellows.
I've been thinking about something like that. Have you made one that you could post a picture of?