Melodeon.net Forums

Discussions => Instrument Design, Construction and Repair => Topic started by: nemethmik on July 24, 2011, 10:21:09 AM

Title: How to open the box of a Hohner Piccoletta
Post by: nemethmik on July 24, 2011, 10:21:09 AM
I cannot find any bellows pins. How to open the box?
Your help would be highly appreciated.
Title: Re: How to open the box of a Hohner Piccoletta
Post by: Sandy Flett on July 24, 2011, 11:25:49 AM
If it is the same era as the Shand Morino then it may have a locking lever behind the treble keyboard.
Title: Re: How to open the box of a Hohner Piccoletta
Post by: Martyn on July 24, 2011, 11:33:07 AM
I cannot find any bellows pins. How to open the box?
Your help would be highly appreciated.

It's the same as a Club Modell 1.
Just remove the grille and remove the two long screws. The same applies to the bass end.

Martyn
www.melodeonrepairs.co.uk
Title: Re: How to open the box of a Hohner Piccoletta
Post by: nemethmik on July 25, 2011, 11:01:19 AM
Thank You, Martyn! One more question, is it possible to replace the bass buttons on a Hohner Picoletta with new Hohner mushroom style buttons? How can I remove the old buttons and install the new ones?
Title: Re: How to open the box of a Hohner Piccoletta
Post by: Martyn on July 25, 2011, 11:39:19 AM
Thank You, Martyn! One more question, is it possible to replace the bass buttons on a Hohner Picoletta with new Hohner mushroom style buttons? How can I remove the old buttons and install the new ones?


It can be a bit tricky removing the old bass buttons as they can become quite brittle.
If I was doing it I would remove the rods that the buttons are attached to by taking out the small pins that connect them to the levers. Then put the rods in a vice and pull the buttons off by hand, sometimes applying  heat to the rod will help a bit. A soldering iron works well.
The replacement buttons can then be fitted, these will be easier to fit if the end of the rod is heated first. Now is also a good time to replace the felt washers.
If the pins have been removed carefully these can be re-used, or a veneer pin of a suitable diameter can be cut to length.
I would only replace the bass buttons if they were broken and then use a matching old one rather than using new.

Hope this is of some help.

Martyn
www.melodeonrepairs.co.uk
SimplePortal 2.3.5 © 2008-2012, SimplePortal