Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: How to open the box of a Hohner Piccoletta  (Read 2120 times)

0 Members and 1 Guest are viewing this topic.

nemethmik

  • Guest
How to open the box of a Hohner Piccoletta
« on: July 24, 2011, 10:21:09 AM »

I cannot find any bellows pins. How to open the box?
Your help would be highly appreciated.
« Last Edit: July 24, 2011, 10:31:03 AM by Miklos Nemeth »
Logged

Sandy Flett

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 709
    • Accordion and Melodeon Blog
Re: How to open the box of a Hohner Piccoletta
« Reply #1 on: July 24, 2011, 11:25:49 AM »

If it is the same era as the Shand Morino then it may have a locking lever behind the treble keyboard.
Logged
DG Dino Baffetti Carnival II (plus accordions)
Accordion and Melodeon blog

Martyn

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 455
  • Hohnerohner
    • Martyn White Melodeon Tuning and Repairs
Re: How to open the box of a Hohner Piccoletta
« Reply #2 on: July 24, 2011, 11:33:07 AM »

I cannot find any bellows pins. How to open the box?
Your help would be highly appreciated.

It's the same as a Club Modell 1.
Just remove the grille and remove the two long screws. The same applies to the bass end.

Martyn
www.melodeonrepairs.co.uk
Logged
'Anything from a small repair to a full restoration'.
www.melodeonrepairs.co.uk

nemethmik

  • Guest
Re: How to open the box of a Hohner Piccoletta
« Reply #3 on: July 25, 2011, 11:01:19 AM »

Thank You, Martyn! One more question, is it possible to replace the bass buttons on a Hohner Picoletta with new Hohner mushroom style buttons? How can I remove the old buttons and install the new ones?
Logged

Martyn

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 455
  • Hohnerohner
    • Martyn White Melodeon Tuning and Repairs
Re: How to open the box of a Hohner Piccoletta
« Reply #4 on: July 25, 2011, 11:39:19 AM »

Thank You, Martyn! One more question, is it possible to replace the bass buttons on a Hohner Picoletta with new Hohner mushroom style buttons? How can I remove the old buttons and install the new ones?


It can be a bit tricky removing the old bass buttons as they can become quite brittle.
If I was doing it I would remove the rods that the buttons are attached to by taking out the small pins that connect them to the levers. Then put the rods in a vice and pull the buttons off by hand, sometimes applying  heat to the rod will help a bit. A soldering iron works well.
The replacement buttons can then be fitted, these will be easier to fit if the end of the rod is heated first. Now is also a good time to replace the felt washers.
If the pins have been removed carefully these can be re-used, or a veneer pin of a suitable diameter can be cut to length.
I would only replace the bass buttons if they were broken and then use a matching old one rather than using new.

Hope this is of some help.

Martyn
www.melodeonrepairs.co.uk
« Last Edit: July 25, 2011, 05:21:15 PM by Martyn »
Logged
'Anything from a small repair to a full restoration'.
www.melodeonrepairs.co.uk
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal