Easy to make, sized to fit specific bellows. 1. Cut slats to fit short dimentions of bellows end frames, two for each end, with blunt taper on short edges of slats which will fit inside bellows where they attach to bellows frames.
2. Cut wooden dowels to the length you wish to extend the bellow to. Slightly taper the ends of dowels to fit undersized holes drilled in the center of the face of slats made on step 1
3.fit two slats in each end of bellows as described in step 1
4 insert dowels inside bellows, slightly overextend bellows to allow fitment of tapered dowel end onto holes in end slat pairs. Do this for both stats/dowel pair.
This works well for holding bellows open to work on the outside of the bellows ,such as retaping,repapering, metal corner work, gusset repair.
If working on the inside of the bellows, I clamp slats to the outside of the bellows frames which extend beyond the width of the frames. On the outside of the bellows, I use either dowels in a method simiar to that described inside the bellows or I have bar clamps which can be used as spreaders between the slats to hold the bellows open for inside side work such as patching. By using two pairs of spreaders for one set of bellows, if one set temporarily interfers with the work area, it can be repositioned as needed.