tedrick and Lars,
I agree with Lars, it was not a dumb question -- it can be done and it can be worth doing. But it takes some special skills and a lot of forethought to avoid botching the job.
I personally have done this, and the results were great. I'm not a machinist, but I had the help of an excellent one for the parts I needed.
I do remember Aldo Mencacini, expert on Paolos, telling me that you couldn't do it with some models, depending on the keyboard angle. So some careful measurement, planning, and comparison of your stepped-board-possible-project with similar flat-keyboard models would be a good idea. That's what I did.
Then there is the issue that to do conversions like this may be compromising the originality of a fine old musical instrument that might be valued by some one else just the way it was made. I do worry about this and always try to do a little research to see if the instrument might more appropriately be left original. Also, I try to use the most reversible means possible when I have made the decision to alter an instrument from its build specifications, and where possible save all original parts, so that a later musician might be able to restore it if that comes to seem a wiser decision.
Remember that what you value about an instrument today may not be what is ultimately most valuable about it to someone else. The antiques roadshow for example is full of cases where one (temporary) owner's decision to personalize or alter an item drastically compromises its value later.
Ultimately it might be better value for you to find an accordion that is already in the condition you want for playing, unless you are especially skilled or are willing to take on a project for its own sake. A lot of such projects with antique cars, accordions, etc. consume more cost and time than the final result is worth.
Good luck!
PG