I know a guy who had a wire coathanger taped inside his bellows to stop it imploding! Of course, he had a ribbon to hold the box closed as the straps no longer reached... Eventually (about two years) he had new bellows made.
I was wondering whether it was feasible to replace the leather diamonds on otherwise OK bellows?
Rob.
Now this job takes a little patience as it can be a little fiddly.
Start off by stretching the bellows by using two timber diagonal braces within the bellows, try to get them to rest up against the frames.
Now you have to try and peel back the bellows tape without tearing it on the offending corners.
I have a tool that I have made up so that I can slightly lift the metal corner, sometimes you can take the corner right off without tearing the bellows board or fabric.
Then try and lift and fold back the bellows papers until all the diamond is exposed, some of the bellows makers used hide glue so with a bit of luck you might be able to lift them off without using moisture, but if all fails use a little water.
Replace the diamond with hide or rabbit skin glue, if you do not have that then PVA will service.
When it comes to gluing on the corner I use PVA Craft Glue, but contact adhesive will again service here.
Crimp the corner up with a parallel jawed pliers or use a small bull nose cutter (not to hard) as second best.
Best of luck
Peter