If this is a hohner bravo then this is a problem I have run into. The plating on the parts can be really rough, or flake off.
I would knock off any loose plating on the friction areas of the rods, but try and avoid grease if you can.
Try graphite , it is a bit messy, but won't make future repairs a problem. If the comb that the rod passes through is worn by the bad plating ,you can build it back up by making a shim out of card stock to take up the play. Set the shim in place (leave the rod out for the moment) and touch the shim with a drop of super glue (thick if you can get it) or if you are patient use wood glue. The paper shim should glue to the wood and fill in the wear. Use a paper clip or the like to press the shim in place. Let it harden and you can file or sand the slot to size if needed.
You can use a soft lead (graphite) pencil to apply graphite where it is needed, without making a mess.
Polish the rod if you can, to prevent future wear.