Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: New Base Layout  (Read 1310 times)

0 Members and 1 Guest are viewing this topic.

deltasalmon

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1002
New Base Layout
« on: July 27, 2013, 03:44:41 PM »

I posted this before but I recently purchased a new C#/D melodeon and this is the base layout that it came with:

(top of instrument)
                outside   inside
chord        G/C           F#/B
bass         G/C           F#/B
chord        D/G           A/E
bass         D/G           A/E

As I started playing more tunes with basses as well as melody I decided that I did not like this layout and wanted to change it to match the more common "standard" layout or the Jackie Daly layout as talked about here. So yesterday I did some work on it.

To match the Jackie Daly layout the F#/B bass was good as it is. The A/E was the right bass but in the wrong position so the first thing I did was to switch the reeds from A/E to G/C and vice versa. Next was the more important change. I didn't like having the D/G bass and would much prefer the D/A bass that would allow me to play along the D row as if it were a 1-row and have the bass to match. I had new hohner reed blocks and reeds for the bass side of a GCF accordion in my basement (I ordered them hoping the blocks would fit a reedless three row accordion I have but they didn't so they had been sitting unused). The GCF bass had a A/D pair so I took them out and spun them around and put them instead of the D/G bass on my C#/D. After all the reeds were installed, waxed in and tested to make sure I had them all where they should be I was left with this:

(top of instrument)
                outside   inside
chord        A/E           F#/B
bass         A/E           F#/B
chord        D/A           G/C
bass          D/G           G/C

Not quite the Jackie Daly layout but I'm getting closer. You might have noticed that the bottom-outside pair is D/A for the chord and D/G for the bass. Unfortunately this is not a typo. The chord reeds from the Hohner block fit in no problem but when I took out the bass reeds I noticed the Hohner reeds were much wider than the ones in my Weltmeister and would not fit.

Is it possible to buy just two reeds for the D/A bass without having to buy a whole set?

The dimensions of the reeds that I need are: 2" x ⅝" x ⅛" and 2¼" x ¾" x ¼"

I didn't have a metric ruler but google tells me these are about 51mm x 16mm x 3mm and 57mm x 19mm x 6mm
« Last Edit: July 27, 2013, 03:46:27 PM by deltasalmon »
Logged
Sean McGinnis
Bordentown City, NJ, USA
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal