Hello All,
I'm just replacing springs in an old Weltmeister for a friend (Like this: eBay item number: 151095928108)
With a 'closed' keyboard that has been assembled around the levers and has no removeable panel, that in itself is something of a challenge.
I'm up for challenges, but the plan was to limit the button travel and so far that HAS got me stumped.
Plan A, a travel limiter under the buttons, doesn't work because the springs are in the way. Plan B was to glue a strip along the top inner edge of the keyboard just above the levers to limit their upward movement - but has two problems: the construction tolerances are so wide that every button would have slightly different travel, and it would put an increased load on the axle/pivot area.
Plan C could be something to restrict the movement of the pallets off the soundboard but looks like a non starter as the levers are very flimsy and would quickly be bent by even a moderately heavy fingered player. (Even more than they already are!)
Any other suggestions gratefully considered

I suspect it's best regarded as a very basic instrument best accepted with its limitations, and then quickly passed on when those become an obstacle.
Thanks,
Graham