I had a sluggish/sticking key on one of my one-row boxes. After eliminating other potential causes, I determined it was due to friction where the axle rod passes through the wooden key. I removed the axle rod and discovered that the axle itself passed through a metal conduit which ran through all the keys and keyboard, but which had been cut so as to be sectioned-off for each key, etc. The only key that didn't have the conduit was the one that was sticking, so I took a drill bit of the *exact* same diameter of the existing hole and simply passed it through using my fingers, rolling it as I went. Well, it turned out to be too much, and while the sticking key is no longer a problem, the issue is that it now sits too loose on the axle! I figured I was safe because I was using a drill bit that could already pass through the opening, and made sure not to use a power tool. It sure didn't take much...
Fortunately, the instrument still plays fine, however the one key that is now a little loose results in a pallet that doesn't quite sit where I'd like it to. I'd like to fix the issue, and the only solution I can see is to somehow reduce (marginally!) the hole in the key. Any tips?