I have in my workshop a newer, nearly unplayed HA114 that is in need of some work. For one, it looks as though the bellows pin holes were poorly drilled at the factory; some are actually drilled at an angle that nearly caused a blowout, but the larger issues is that the treble and bellows frames aren't pulled tightly together enough to compress the bellows gasket sufficiently. A new gasket would not solve the issue since the existing one is already 'new' and uncompressed. My inclination would be to fill the existing holes and re-drill all four bellows pin holes on the treble/bellows frame ends, however I want to make sure that I don't end up just drilling out what was filled in and start back at square one. Normally I would use a combination of glue and a wooden skewer/dowel and just squeeze it into the hole as tight as it can go, cut off the excess and drill again. I think I've had mixed results in the past - I can't remember. Any recommendations?