Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Bellows pin holes  (Read 503 times)

0 Members and 1 Guest are viewing this topic.

mselic

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1683
Bellows pin holes
« on: September 04, 2023, 04:01:19 PM »

I have in my workshop a newer, nearly unplayed HA114 that is in need of some work.  For one, it looks as though the bellows pin holes were poorly drilled at the factory; some are actually drilled at an angle that nearly caused a blowout, but the larger issues is that the treble and bellows frames aren't pulled tightly together enough to compress the bellows gasket sufficiently.  A new gasket would not solve the issue since the existing one is already 'new' and uncompressed.  My inclination would be to fill the existing holes and re-drill all four bellows pin holes on the treble/bellows frame ends, however I want to make sure that I don't end up just drilling out what was filled in and start back at square one.  Normally I would use a combination of glue and a wooden skewer/dowel and just squeeze it into the hole as tight as it can go, cut off the excess and drill again.  I think I've had mixed results in the past - I can't remember.  Any recommendations?
Logged
C#/D player

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Bellows pin holes
« Reply #1 on: September 04, 2023, 04:04:46 PM »

I find the drill tends to follow the filled hole when I do that.  Using a drill press and clamping the box to be drilled might help, but 2mm drill is a bit flexible and might still wander.  Maybe drill out to 2.5mm and use Italian pins?
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

tirpous

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1403
Re: Bellows pin holes
« Reply #2 on: September 04, 2023, 06:09:20 PM »

A predrilled hardwood guide block clamped to the box would help ensure the hole is where you want it.
Logged

Lester

  • MADman
  • Mods and volunteers
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 9327
  • Hohners'R'me
    • Lester's Melodeon Emporium and Tune-a-Rama
Re: Bellows pin holes
« Reply #3 on: September 04, 2023, 06:14:17 PM »

I do the same as you and glue and plug the holes (usually only the ones in the frames). Then I remove the gasket, fit the bellows a drill the holes. This ensures the gasket gets well compressed when it is refitted.
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal