Hi Guys/Gals got a few 3D printed parts back from my mate
The little joints (1mm slot)are to avoid either loop bending rods or convert steel strips to rods (Like Club 2)
Not sure how they will wear with time but my tests with a split pin fishing leader and some old weights they seem very strong
I flux strip welding rods and the buttons and little joint holes are a great push in snug fit
Just waiting for an experimental test fondo with coupler slides/stops inside the fondo .
I has some reservations but I think with the precision that these things print it will be fine and 4 buttons sprung basically a copy of a chromatic harmonica
slide button but with a stop latch
Now to draw the reed blocks, but the good thing is once its in the cad programme you can just change the length to accommodate
different keys and spacing
As to printing frames I,m still a bit of a traditionalist ,and not sure about buttons or button plates or anything visible being 3Dprinted
I will see what they look like and should be very light as you can change from solid (bellows pins edge and front edge)to lattice? printing
like honeycomb
I will post pics if anyone's interest as the bits arrive