Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: 1 [2]   Go Down

Author Topic: Making a melodeon case  (Read 8263 times)

0 Members and 1 Guest are viewing this topic.

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: Making a melodeon case
« Reply #20 on: March 19, 2013, 10:03:46 AM »


There is a felt available which is self adhesive and is specifically made for lining boxes.
It's quite difficult to use because once you apply it to the surface it's there for good.
Check out  J Hewitt and son in Scotland. It is  acid free and won't harm the contents.
I've made several concertina and melodeon cases over the years. When lining the interior of boxes, it is easiest to apply the lining material to one side of a sheet of thin card, with a small mitred overlap on the rear. Each sheet of card has the dimensions of one interior panel of the box minus about 1 mm along adjacent panel corners. The card gives the lining material some stiffness and enables it to be easily manipulated into place. Make pieces like this to cover all the internal surfaces of your box.

Once you have glued your felt (or covered foam, whatever you are using) to the card, you can then glue it to the wood surface of the box interior using high-tack PVA glue. Works a treat!
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: Making a melodeon case
« Reply #21 on: March 19, 2013, 10:20:24 AM »

..............
Choice of foam inside will be dictated by whether you can fabric line it or not.  If you don't have a lining, then be sure your foam won't produce dust - the worst enemy of a free reed instrument.

Rob.

I have just made a case but didn't line it yet.
In fact I wasn't going to bother with lining, just use foam, but having read this comment about dust, I am having second thoughts.
I have seen foam turn to dust before, but I thought I might just replace it if and when this starts to happen.
I think now though that I might line it.
Any tips on the best material to use and method would be appreciated.
As mentioned in my previous post, I've made several wooden cases for concertinas and melodeons. My preferred lining material is upholstery foam sheet (about 1 cm thick, uncompressed) covered by plush furry 'teddy bear' material, obtainable in various colours from craft suppliers.

I use thin card carrier sheets as a foundation for each interior panel of the box (see previous post). First, I cut a piece of foam to the same dimensions of the card carrier sheet and glue the foam to one side of the card with impact-type adhesive, e.g. Bostik 'Clear'.

Next, I cut a piece of furry plush material sufficient to cover the foam side, plus a 2-3 cm mitred overlap on the rear of the card. I glue this in place also using impact-type adhesive. 

Finally, I glue each plush/foam/card assembly into place on the wooden interior panels of the box, using either impact adhesive or PVA glue. Remember to glue the card side to the wood, not the furry side.  ;D

My boxes made in this way have protected my instruments well over the years and I have never had any problems from degradation of the foam, failure of the adhesives, etc. The only precaution I take using impact adhesives as described, is to allow the completed box to 'air off' with the lid open for 3 or 4 days to allow any excess organic solvents from the glues to evaporate off, prior to putting the instrument in the box.
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

911377brian

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1518
Re: Making a melodeon case
« Reply #22 on: March 19, 2013, 11:32:24 AM »

You'd be amazed what you can find in a good government store [like the one we have in Exeter], boxes and bags. One of mine is an old Aldis signal lamp box.... ;)
Logged

Andrew Wigglesworth

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1101
  • 07
    • My website
Re: Making a melodeon case
« Reply #23 on: March 19, 2013, 12:02:18 PM »

..............
Choice of foam inside will be dictated by whether you can fabric line it or not.  If you don't have a lining, then be sure your foam won't produce dust - the worst enemy of a free reed instrument.

Rob.

I have just made a case but didn't line it yet.
In fact I wasn't going to bother with lining, just use foam, but having read this comment about dust, I am having second thoughts.
I have seen foam turn to dust before, but I thought I might just replace it if and when this starts to happen.
I think now though that I might line it.
Any tips on the best material to use and method would be appreciated.

On the case I made for my Baffetti I used closed cell foam, as used in camping sleeping mats. In fact it was a battered old sleeping mat that I used. This is covered in a "fur" fabric.

I've not seen age related deterioration of the closed cell foam in used these sleeping mats and I have some pretty old ones.

strad

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 418
Re: Making a melodeon case
« Reply #24 on: March 19, 2013, 01:10:31 PM »

Would the baize used for snooker/pool tables be suitable for a lining? Should be reasonably dust free and will vacuum ok. Repairers of such tables would most likely sell you some.

Nigel
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Making a melodeon case
« Reply #25 on: March 19, 2013, 01:47:24 PM »

Would the baize used for snooker/pool tables be suitable for a lining?

Very, very expensive though.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Prestidigitator

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 448
  • Saltarelle, Hohner, Oakwood Baffetti
Re: Making a melodeon case
« Reply #26 on: March 19, 2013, 02:01:27 PM »

Would the baize used for snooker/pool tables be suitable for a lining?

Very, very expensive though.

It sure is. I've used 100% wool 4mm thick felt from these folks http://www.woolfeltcompany.co.uk/ for some small case lining repairs. It's gorgeous stuff, and comes in nice colours, but a metre length x 45cm width is currently £30.
At those rates, there's a danger the case will be more valuable than the contents.
Logged

tedrick

  • Guest
Re: Making a melodeon case
« Reply #27 on: March 26, 2013, 01:49:42 PM »

this looks like a nice design for a small box:
from that Lilly auction awhile back -
Logged

911377brian

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1518
Re: Making a melodeon case
« Reply #28 on: March 26, 2013, 03:36:34 PM »

Aradru..Well spotted! I've just bought it..hope I've done the right thing..tend to get a bit over enthusiastic at times.. ::)
Logged

911377brian

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1518
Re: Making a melodeon case
« Reply #29 on: March 26, 2013, 03:39:49 PM »

Should have said in the above that I make most of my boxes but they always cost wellover £20 to finish nicely..
Logged

911377brian

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1518
Re: Making a melodeon case
« Reply #30 on: March 26, 2013, 07:45:26 PM »

@Aradru..I'll let you know as soon as it arrives. As for cost of making a box,the handles are expensive unless you get an old suitcase from a charity shop, and lining the thing nicely is'nt cheap...
Logged

Kimric Smythe

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 712
    • Smythe's Accordion Center
Re: Making a melodeon case
« Reply #31 on: April 02, 2013, 05:21:19 PM »

..............
Choice of foam inside will be dictated by whether you can fabric line it or not.  If you don't have a lining, then be sure your foam won't produce dust - the worst enemy of a free reed instrument.

Rob.

I have just made a case but didn't line it yet.
In fact I wasn't going to bother with lining, just use foam, but having read this comment about dust, I am having second thoughts.
I have seen foam turn to dust before, but I thought I might just replace it if and when this starts to happen.
I think now though that I might line it.
Any tips on the best material to use and method would be appreciated.

On the case I made for my Baffetti I used closed cell foam, as used in camping sleeping mats. In fact it was a battered old sleeping mat that I used. This is covered in a "fur" fabric.

I've not seen age related deterioration of the closed cell foam in used these sleeping mats and I have some pretty old ones.

This is the method I use. I often cover the foam with stretch ,or cotton velvet.
Logged
Smythe's Accordion Center
Pinole, California
Sales and repairs since 1997
Pages: 1 [2]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal