Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Cleaning up my melodeon  (Read 6737 times)

0 Members and 1 Guest are viewing this topic.

Steve Fox

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 256
Cleaning up my melodeon
« on: November 22, 2008, 08:58:26 AM »

Not sure whether this is the right section to post this, but here goes.  Does anyone have any advice on how to get the pearloid on boxes like the Hohner Erica looking bright and shiny again?
Logged
Steve from Wakefield

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Cleaning up my melodeon
« Reply #1 on: November 22, 2008, 09:14:15 AM »

I find that Unipol plastic polish works well, but it will not remove deep scratches. 
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

boxlad

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 291
    • Ray Ó Díomasaigh
Re: Cleaning up my melodeon
« Reply #2 on: November 22, 2008, 09:35:01 AM »

Hi Theo, Unipol says to rub it in with a wet cloth..Is water not damaging to this type of surface? Should these instructions be followed or should I use a dry cloth to apply the polish??
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Cleaning up my melodeon
« Reply #3 on: November 22, 2008, 10:34:23 AM »

A damp cloth is ok, just so long as no water can squeeze out while polishing.

And I should also have suggested using a detergent first if you need to remove any greasy/sweaty residue.  Again on a slightly damp cloth.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Falseknight

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 449
    • False Knight
Re: Cleaning up my melodeon
« Reply #4 on: November 22, 2008, 11:42:31 AM »

I've used Brasso on plastic components many times in the past, also for removing film, grease and the oxidised surface layers of paint and varnish from guitars and such like.  It is a very mild abrasive indeed and tends not to leave marks.  Just remember to use it VERY sparingly.
Logged

an bosca ceoil

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 347
Re: Cleaning up my melodeon
« Reply #5 on: November 22, 2008, 01:34:47 PM »

Celluloid is a lot tougher than you might think, but the lettering is NOT and easily "polished" away.
When cars were finished with cellulose based paint they had to be "flatted" with fine abrasive paper to remove the worst imperfections then polished up using progressively finer grades of cutting paste. Many refinishers did use Brasso for the final finish.
This method can be used to remove all but the deepest abrasions on "pearloid" because the pattern goes right through, but ideally the casing needs to be stripped down and you need a lot of elbow grease or a polishing mop.
If you are just looking to a light clean and polish Brasso is ideal, as are many of the mildly abrasive paint "colour revivers" you can find in places like Halfords as T-Cut. All of these will leave a fine residue in any scratches and leave the surface so clean that it will benefit from an application of  actual polish to prevent it picking up  new dirt.
(There used to be a polish called Mer, recommended for cellulose and plastics, if you can find/afford it!)
Whatever you use, try it out somewhere it will not notice and go easy on the "transfers"!
Logged

Steve Fox

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 256
Re: Cleaning up my melodeon
« Reply #6 on: November 25, 2008, 03:06:42 PM »

Thank you, everybody, for your advice.
Logged
Steve from Wakefield

nousuvesi

  • Member
  • *
  • Offline Offline
  • Posts: 20
Re: Cleaning up my melodeon
« Reply #7 on: November 27, 2008, 04:51:51 AM »

The first fella I took accordion lessons from years ago used paint thinner to clean his accordions, I always thought he was nuts but it did work.

Nathan
Logged
Nathan S.

RGF

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 214
Re: Cleaning up my melodeon
« Reply #8 on: November 27, 2008, 05:10:05 AM »

Ahh, but we've got to be careful here about our terminology, as there is "paint thinner", and there is "paint thinner".  Mineral spirits is paint thinner, and a quite benign solvent. I've used it to clean gummy old spots off countless objects - including accordions - over the years.  But lacquer thinner is also a paint thinner, and I don't think you want to go anywhere near celluloid with that stuff!

Bob
Logged

Falseknight

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 449
    • False Knight
Re: Cleaning up my melodeon
« Reply #9 on: November 27, 2008, 10:21:27 AM »

MEK (methyl ethyl ketone) is also a common solvent/paint thinner and will dissolve many plastics and lacquers very quickly.  Keep well away.
Logged

Martin J

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 902
  • Poole, Dorset
Re: Cleaning up my melodeon
« Reply #10 on: November 27, 2008, 05:23:47 PM »

MEK (methyl ethyl ketone) is also a common solvent/paint thinner and will dissolve many plastics and lacquers very quickly.
AND ALMOST ANYTHING ELSE IN SIGHT INCLUDING YOUR LUNGS.
Logged
Castagnari, Weltmeister, Giustozzi, Streb, too many Hohners.  No Strings Attached ceilidh band

finnhorse

  • Guest
Re: Cleaning up my melodeon
« Reply #11 on: November 27, 2008, 11:25:11 PM »

MEK (methyl ethyl ketone) is also a common solvent/paint thinner and will dissolve many plastics and lacquers very quickly.  Keep well away.

and don't clean LPs or shellac 78's with it either.  It'll wipe the grooves away.
Logged

Pete Dunk

  • Typo Expert
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3706
Re: Cleaning up my melodeon
« Reply #12 on: November 27, 2008, 11:37:14 PM »

[UK English] Don't get cellulose thinners anywhere near a melodeon chaps. Might be a good idea not to drink more than a couple pints a day either, apparently it's a tad aggressive. [/UK English]  ;D
Logged
Squeezing on the Isle of Oxney, UK
Primo (Serenellini) D/G
Isis D/G
Hohner B/E, G/C, C/F, Bb/Eb G/C/F
Liliputs D/G (G scale), C/F, Bb/Eb, Albrecht Custom D/G (G scale)

Pete Dunk

  • Typo Expert
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3706
Re: Cleaning up my melodeon
« Reply #13 on: November 28, 2008, 12:12:18 AM »

and don't clean LPs or shellac 78's with it either.  It'll wipe the grooves away.
Were 78's really made of shellac? I'm truly stunned, I had no idea. It does explain why they were so fragile and easily shattered though.

We live and learn; sometimes in an extraordinary manner!
Logged
Squeezing on the Isle of Oxney, UK
Primo (Serenellini) D/G
Isis D/G
Hohner B/E, G/C, C/F, Bb/Eb G/C/F
Liliputs D/G (G scale), C/F, Bb/Eb, Albrecht Custom D/G (G scale)

Malcolm Austen

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 495
  • any old hohner
Re: Cleaning up my melodeon
« Reply #14 on: November 28, 2008, 08:16:42 AM »

Save the Lac
Logged
aka malodeon

Falseknight

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 449
    • False Knight
Re: Cleaning up my melodeon
« Reply #15 on: November 28, 2008, 04:55:22 PM »

General notes on available solvents:

White spirit:- good for grease and metal bits, generally does not damage wood, paint or plastics.  Flammable

Methylated Spirits:-  Good degreaser and cleaner, does not affect paint, plastic or celluloid.  Dissolves shellac varnish varnishes and resins.  Very flammable,.

Isopropyl Alcohol:-  As above bot not quite s flammable.  Often found in switch cleaner

Trochloroethane (etc);  Used to be known by the trade name Genklene, is now mainly banned as a greenhouse gas contributor (Montreal Protocol).  Not particularly harmful to most finishes and only harmful to health if you insist on smoking while using it.  Be warned that the Genklene brand name continues with "other stuff" as active constituent.

MEK:  Also known as cellulose thinners - dissolves most organics to some degree, especially nitro-cellulose finishes, celluloid etc.  Not good for lungs.  Keep away from instruments.

Acetone:  This has found it's way into aerosol industrial degreasing agents since it is less environmentally harmful than tricloroethane.  Very, very flammable indeed (second worst agent for a Lab fire - ether is the worst), very, very aggressive solvent of cellulose based finishes and plastics.  Shellac has no chance.  Not a very good degreaser in ope air because it evaporates too quickly.

Now if anyone would care to circulate what paint/varnish finishes are in circulation on boxes old and new, we can put together a "what to avoid" list.
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal