Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1] 2 3   Go Down

Author Topic: pokerwork spring  (Read 15242 times)

0 Members and 1 Guest are viewing this topic.

Sandy

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1007
  • 'Musical Landlady'
pokerwork spring
« on: November 28, 2008, 09:18:11 AM »

A spring has broken on the G row in my pokerwork. Is this a diy job or give it to someone who knows what they are doing?
 :-\

Bill the Farmer

  • Not quite so
  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 497
  • Hohner Club, Liliput...
    • Bill Farmer
Re: pokerwork spring
« Reply #1 on: November 28, 2008, 09:58:00 AM »

I had mine apart to fix the same problem a few months ago. I posted some pictures here. To get it apart you:
  • Pull out the bellows pins on the treble end, and take it off;
  • Take off the front grille;
  • Undo the two screws holding the keyboard on, and wiggle it gently off;
  • Release all the springs with a crochet hook, or something similar;
  • Undo all the small screws holding the pallets and key assembly on, and lift it off;
Then you can wiggle the long rod out that holds all the levers in place until you release the broken spring. Careful not to mix the springs up, as they are two slightly different sizes, or the levers. If you don't have a replacement spring, you can temporarily pinch one from the squeaky end, and block off the holes with a bit of tape. Put it all back together in reverse order.
Logged
Bill of Old Radipole Village

Sandy

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1007
  • 'Musical Landlady'
Re: pokerwork spring
« Reply #2 on: November 28, 2008, 10:19:27 AM »

thank you. i know what i have to do now. if all fails then i shall send it to the melodeon clinic!

cheers

sandy
 :)

george garside

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 5401
Re: pokerwork spring
« Reply #3 on: November 28, 2008, 10:38:48 AM »

juat a athought that may or may not have any relevence.  In around 50 years of playing hohners (pokerworks, ericas & double rays) regularly I have never broken a spring - reeds yes but never springs.  Could this be because i tap the buttons lightly rather than shoving them down the holes! I play the boxes as built rather than limiting the button travel by padding or bar etc.  The palette only just needs to come off the holes to let plenty of air in or out to sound the reeds, any furthur degree of opening is just a waste of energy but will  tighten up the spring more everytime a note is played which might result in earlier metal faatigue.  I wonder sometimes if some layers try to use the degree off button press as a volume control wich it isnt - the button is more like an on off switch.

No doubt sods law will now prevail & I will shortly suffer from a broken hohner spring! ;)


george
Logged
author of DG tutor book "DG Melodeon a Crash Course for Beginners".

Bill the Farmer

  • Not quite so
  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 497
  • Hohner Club, Liliput...
    • Bill Farmer
Re: pokerwork spring
« Reply #4 on: November 28, 2008, 12:05:07 PM »

It appears to be the general rule that sooner or later you will break a spring on a Pokerwork or Erica. It took me five years, it took the 14 year old lad in our morris side about 18 months. It's probably a function of how much you play it, and how far you push the buttons. It's difficult to avoid pushing them in when you're learning, you're concentrating on pushing the right buttons in the right order. All the other nuances come later, when you can play a tune while concentrating on getting something else right.  ;D
Logged
Bill of Old Radipole Village

Ebor_fiddler

  • Chris
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2340
  • Hohner 1040 C One-Row, Sandpiper D/G, Liliput C/F
    • Ebor Morris
Re: pokerwork spring
« Reply #5 on: November 28, 2008, 12:11:39 PM »

Yes, even I, as a beginner have noticed that the people who have "temporarally" replaced the odd spring with an elastic band, tend to be the younger ones. It must be all those testosterones thingies they have at that age! "O to be ane and twenty, Tam!"  >:( (Rabbi Burns, God be good to him).
 ;D
Logged
I'm a Yorkie!
My other melodeon's a fiddle, but one of my Hohners has six strings! I also play a very red Hawkins Bazaar in C and a generic Klingenthaler spoon bass in F.!! My other pets (played) are gobirons - Hohner Marine Band in C, Hohner Tremolo in D and a Chinese Thingy Tremolo in G.

Bill the Farmer

  • Not quite so
  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 497
  • Hohner Club, Liliput...
    • Bill Farmer
Re: pokerwork spring
« Reply #6 on: November 28, 2008, 12:49:13 PM »

Yes, I forgot the old elastic band trick.  ;D I did that to a cheap and nasty little East German box that I learnt on. It's virtually impossible to get at the springs inside the keyboard.
Logged
Bill of Old Radipole Village

Malcolm Austen

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 495
  • any old hohner
Re: pokerwork spring
« Reply #7 on: November 28, 2008, 01:35:34 PM »

20 + years and I have not broken a pokerwork or erica spring but one went on the spoon bass of my first 1 row about 10 years from new.
Logged
aka malodeon

pipives

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 275
    • Pip Ives
Re: pokerwork spring
« Reply #8 on: November 28, 2008, 05:13:15 PM »

20 + years and I have not broken a pokerwork or erica spring but one went on the spoon bass of my first 1 row about 10 years from new.

Four Hohners, 12 years of playing, no broken springs. And I AM only 21!  ;D
Logged
Faversham, Kent

Ebor_fiddler

  • Chris
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2340
  • Hohner 1040 C One-Row, Sandpiper D/G, Liliput C/F
    • Ebor Morris
Re: pokerwork spring
« Reply #9 on: November 28, 2008, 09:27:55 PM »

Showoff!  ;D
Logged
I'm a Yorkie!
My other melodeon's a fiddle, but one of my Hohners has six strings! I also play a very red Hawkins Bazaar in C and a generic Klingenthaler spoon bass in F.!! My other pets (played) are gobirons - Hohner Marine Band in C, Hohner Tremolo in D and a Chinese Thingy Tremolo in G.

BruceHenderson

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 262
Re: pokerwork spring
« Reply #10 on: November 28, 2008, 10:15:06 PM »

juat a athought that may or may not have any relevence.  In around 50 years of playing hohners (pokerworks, ericas & double rays) regularly I have never broken a spring - reeds yes but never springs.  Could this be because i tap the buttons lightly rather than shoving them down the holes!  (snip)

     In Quebec these days, t's a strongly encouraged way of pushing the buttons (esp. by Raynould Ouellet and some others) to play by laying your fingers flat across buttons and button board (sort of like fingering an Irish bagpipe).  I've tried it and I like it.  It takes a lot of stress off your fingers and off the buttons.  Doesn't work on the stepped two-row, though (at least not on the G-row of my Hascy).
« Last Edit: November 30, 2008, 01:38:14 AM by BruceHenderson »
Logged
I love one-rows!  Four reeds kick butt!!!!

Sandy

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1007
  • 'Musical Landlady'
Re: pokerwork spring
« Reply #11 on: November 28, 2008, 11:56:29 PM »

I now wonder whether one should be a bit red faced about losing a spring on their melodeon?

This pokerwork is my second box that has been laying dormant for a fairly long time. Wondered if changes in atmospheric conditions might affect the springs?
 
Actually I blame John Kirkpatrick and his tutorial dvd. I was trying to copy his Jenny Lind Polka with all the r.h. chording on the third time through.

Learning everyday,

Sandy.
 :)

Falseknight

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 449
    • False Knight
Re: pokerwork spring
« Reply #12 on: November 29, 2008, 12:22:44 AM »

A general, not a personal comment:

Springs corrode if left.  Corrosion provides initiation sites for metal fatigue so rusty springs fail sooner.
Logged

nousuvesi

  • Member
  • *
  • Offline Offline
  • Posts: 20
Re: pokerwork spring
« Reply #13 on: November 30, 2008, 01:26:27 AM »

I have a question about this elastic band trick. What is it?

I own a cheap german one row that happens to have a broken spring and as you would expect the keyboard is completely inaccessible.

(I got the box 2nd hand but the spring did give on my watch)
Logged
Nathan S.

Bill the Farmer

  • Not quite so
  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 497
  • Hohner Club, Liliput...
    • Bill Farmer
Re: pokerwork spring
« Reply #14 on: November 30, 2008, 10:53:40 AM »

As far as I remember, you take the treble end off, same as above/below, take the front grille off, and take the keyboard off, except that the whole thing comes off, complete with levers and pallets. Then you loop an elastic band over the lever with the broken spring, so that the rest of the elastic band is hanging out of the bottom. Then you put the keyboard back on, putting a bit of tension on the elastic band as you do up the screws. You just leave the elastic band hanging out the bottom for street cred purposes.
Logged
Bill of Old Radipole Village

Quebecois

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1206
  • Accordez-vous donc, c'est si beau, l'accordéon!
Re: pokerwork spring
« Reply #15 on: November 30, 2008, 11:40:57 AM »

     In Quebec these days, t's a strongly encouraged way of pushing the buttons (esp. by Raynould Ouellet and some others) to play by laying your fingers flat across buttons and button board (sort of like fingering an Irish bagpipe).  I've tried it and I like it.  It takes a lot of stress off your fingers and off the buttons. <snip>
Yes, I find that a good technique too. No need to put felt or rubber pads under their keys to limit the travel either; playing like that seems more practical and naturally limits the movement of the keys while allowing for fast playing.
Logged
Hohner Morgane D/G, pre-Erica Hohner in C/F and G/C,
Hohner Erica A/D, Roland FR-18

finnhorse

  • Guest
Re: pokerwork spring
« Reply #16 on: November 30, 2008, 11:47:19 AM »

Quote
. . .Then you put the keyboard back on, putting a bit of tension on the elastic band as you do up the screws. You just leave the elastic band hanging out the bottom for street cred purposes.

I hear that rapper 50 Cent has 9 such elastic bands hanging out of his melodeon!   ;D

You've provided an excellent illustration.  Much better than Roger Watson's diagram for the same operation, provided in the last page of Handbook For Melodeon.
Logged

Lester

  • MADman
  • Mods and volunteers
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 9327
  • Hohners'R'me
    • Lester's Melodeon Emporium and Tune-a-Rama
Re: pokerwork spring
« Reply #17 on: November 30, 2008, 12:02:54 PM »

My version of the elastic band trick seem simpler than Bill's:

  • Remove the grill
  • Push a drawing pin in as near the front as possible above the broken spring  position
  • Loop elastic band around drawing pin
  • Using a paper clip hook other end on to arm of button (if i remember correctly Hohners has a convenient hole in the arm)
  • Fiddle with elastic band to get correct tension

And then Roberts your father's sibling!

Bill the Farmer

  • Not quite so
  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 497
  • Hohner Club, Liliput...
    • Bill Farmer
Re: pokerwork spring
« Reply #18 on: November 30, 2008, 07:09:35 PM »

And then Roberts your father's sibling!

No street cred, though ;D
Logged
Bill of Old Radipole Village

nousuvesi

  • Member
  • *
  • Offline Offline
  • Posts: 20
Re: pokerwork spring
« Reply #19 on: November 30, 2008, 09:52:25 PM »

Thanks Bill, I will give it a try.
Logged
Nathan S.
Pages: [1] 2 3   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal