very cool!
what did you use for the cabinet?
Reed
The top of the cabinet is a 4 foot oak stair-tread from Home Depot, for about $20 as I recall. I chopped it at 24 inches and biscuit joined the two pieces back to back, adding a bit of matching molding to cover the raw edge. That provides the thickness required for using hanger bolts to mount the chair base and is strong enough to support the leverage of the monitor's arm.
Rolling chair bases are typically angled, whereas I wanted the top to be horizontal. I used hangar bolts (wood screw <> machine screw) to form levelers by trapping the chair base part between two nuts. I have since found another abandoned chair base -- they are everywhere once you start noticing -- with a built in tilt adjustment, which would have allowed screwing the top to the base without levelers. It's slated for version 2: Son of Wheelie.
For the skirt, three sides are 3/4 oak veneer plywood, two with biscuit butt joints to each other and to the top and the third hinged to give access to the insides. Strength isn't necessary and I could have gone with thinner stuff but 3/4 scraps were on hand. Thin stuff would have made the wheelie lighter, so perhaps next time.
The chair base featured a footrest that stuck out at a jaunty angle. I used it to mount the fourth side which just happened to be teak veneer chipboard. The black spray job hides lots of scars from the scrap's earlier adventures as a 70's platform bed. Experience has shown that the angle prevents the laptop being scraped off when zooming around corners and helps center weight over the wheels.
The laptop hangs from its docking station, which makes removal easy. Since PC docks are a thing of the past, an alternate configuration features a strip of 2" molding attached to the bottom of that shelf, forming a rest. The shelf's angle lets the laptop lean against the black board and has proved to be secure.
I'm eyeing a much larger and thinner monitor, now that the LED back lit models have gotten to be about the price of an eat-out. Perhaps the wheelie could hide in a corner, pretending to be a digital photo frame. Then it wouldn't have to flee to the closet between sessions.