Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Help with taping of the thirds on a DG Castagnara Lilly  (Read 1540 times)

0 Members and 1 Guest are viewing this topic.

Barry M

  • bmelodeon
  • Good talker
  • **
  • Offline Offline
  • Posts: 89
Help with taping of the thirds on a DG Castagnara Lilly
« on: September 05, 2013, 02:39:49 PM »

Hi
Grateful for any help any one can give with this
I may be getting this all wrong so apologies in advance
Having a while ago got so far as lifting the bass reed assembly out (shown here turned over so reeds are away from you)
Then wondered which holes to tape off to remove the thirds
Also not sure whether I can just put scotch magic tape or a post it note between these two boards before reassembly
Thank you for any help you can give with this
Barry

Logged

deltasalmon

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1002
Re: Help with taping of the thirds on a DG Castagnara Lilly
« Reply #1 on: September 05, 2013, 03:45:03 PM »

I'm not sure how the thirds on a Lilly are.

For my Welty the thirds of the chords (and 1st and 5ths) weren't necessarily the same reed frame for push and pull (i.e. sometimes the root of the push chord and the 3rd of the pull chord were on the same reed frame). I now have a tuning table made out of old bellows but when I first taped off the thirds I just blew into each reed with a guitar tuner to find out which notes were the thirds. I wrote them down on a piece of paper and sort of mapped it all out. Also in the Welty there weren't seperate holes for each reed like your Lilly so I just put scotch tape right on the reed itself.

Good luck!
Logged
Sean McGinnis
Bordentown City, NJ, USA

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Help with taping of the thirds on a DG Castagnara Lilly
« Reply #2 on: September 05, 2013, 04:08:20 PM »

Italian reeds are usually set up with the thirds for push and pull on the same reed plate, so once you have identified the correct reeds you can just tape over the hole in the base of the block.  To identify the thirds it's probably best to to ping the reeds with your fingernail and listen to them to find the correct pitch.  You can narrow it down a bit by pressing a chord button and see which holes open, it will be one of those.  Then press the corresponding bass button and see which of the same three holes opens, that will be the tonic, leaving you with just a choice of two.   Repeat the process for each chord.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Barry M

  • bmelodeon
  • Good talker
  • **
  • Offline Offline
  • Posts: 89
Re: Help with taping of the thirds on a DG Castagnara Lilly
« Reply #3 on: September 07, 2013, 09:24:52 PM »

Thank you for those great replies
Have now used pieces of post it note to block of the thirds
Thank you
Barry
« Last Edit: September 07, 2013, 09:29:08 PM by bm »
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal