Hi I have attempted replacing a wooden sound board in the past. Not sure if supranis is wood or metal
Removing the old damaged sound board was completed by removing celluloid and and splitting frame.(this had to be done as the sound board was located in a rebate within the frame) I dampened glue on joints and behind celluloid with water and used gentle heat (hairdryer) to soften. A wide wallpaper scraper was used to gently prise off the celluloid. the glued joints came apart easily enough.
The sound board I made from three layers of very thin plywood available from model shops (time will tell if that was the correct choice). I clamped the three layers together between two heavier plywood sacrificial pieces marked the holes, (reed and register/slide levers) (Template was the old soundboard) and drilled them by hand and filed/sanded were required. It wasn't perfect but on closer examination of the old soundboard the spacing wasn't perfect either. (The box in question was from around the 1930). Slide groves were cut from what would be the middle layer of thin plywood (Plywood was slightly thicker than the brass slides). All parts glued up and weights placed on top until glue dried. To keep everything aligned the slides were in installed during the glue up I however to prevent them from being glued solid I would move them back and forth every 5 or so minutes. It appears to have worked sound board is installed. Frame is back together (less celluloid I dont know how I will do that may go with an alternative finish). New leather on pallets (treble and base) reeds have been clean re valved) Project not complete by anymeans as life seams to get in the way. I am pretty sure when assembled I will have some fettling to do but I reckon I will get a tune out the box when I have refurbished bellow (and tuned reeds). Box would have been firewood if I hadn't attempted the repair. I have photos somewhere, if anyones interested I will upload some when I get a chance.
Cheers
johnm3487