A little bit of a rundown on a Pilzschler Universal I just finished rebuilding for a customer.
The rundown; 2 reed D/G bronze reeds (louder than expected) -14 cents tuning ,12 bass, 21 keys.
https://www.flickr.com/photos/26639011@N06/14594139926/ The instrument is pretty solid with all wood action (keys / key supports) with some parquetry work. I liked the way you could remove a small panel on the back of the keyboard and replace or adjust the key spring tension.
The deck was solid wood, and the reeds were on zinc plates, so I spent a bunch of time scraping oxides out the reed slots to get the reeds to play properly.
Tuning was not too bad but the low notes were pretty flat. I could not tell if this was intentional or wear related.
Retaped the bellows and replaced the gaskets, rewaxed and revalved reeds ,clearing the reeds of oxides made the tuning process longer than expected.
The one part that was unexpected was dealing with a badly done previous repair. The comb that held the bass button pivots had pulled the wood deck up so it had cracked, someone had just glued the crack and ignored the real problem. I was able to push it back and fit a piece of wood between the comb and the back of the instrument to hold it in the proper place, and keep the strain off the deck. I then drilled pilot holes and used some long thin wood screws to pull the comb back against the deck from the other side of the deck.
I will post pics of the details tomorrow.
In my opinion the instrument was a well made instrument for its time, and was probably expensive. I have two others That I have not restored yet, one is still in the factory box.