Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Replacing worn straps on Liliput  (Read 3178 times)

0 Members and 1 Guest are viewing this topic.

Matthew B

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 894
Replacing worn straps on Liliput
« on: August 17, 2014, 04:40:51 PM »

The bass strap and the shoulder straps on my Liliput are all (suddenly!) starting to wear out, and getting that just-about-to-fail fluffy leather look.  Suggestions about suitable replacements would be much appreciated.  I've seen several references to this on the forum, but the comments are a bit scattered.  I'd rather not replace the strap brackets if I can avoid it, and I'd like to keep some adjust-ability on the bass strap. 

I am currently based fairly close to CGM Music, in case he offers any particularly convenient options.   



Logged
Charter Member Presumpscot and Fore River Accordion Club

Prestidigitator

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 448
  • Saltarelle, Hohner, Oakwood Baffetti
Re: Replacing worn straps on Liliput
« Reply #1 on: August 18, 2014, 07:18:19 AM »

I've used the plainest and thinnest brown straps from CGM to replace Liliput ones. I seem to recall that some scalpel work was needed, but it's not a difficult job. No fitments needed replacement, and the bass strap buckle is still there.

It is possible to source grey chrome leather from leather suppliers like Pittards in the West Country, but it then becomes rather expensive, as it usually comes in the form of large "hides" or pieces of uncut leather. It is also the case that most of these leathers are produced for bags, furniture coverings etc., and are thus not thick enough for straps; but suitable stuff can be had. Unfortunately, thicker means more expensive.
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Replacing worn straps on Liliput
« Reply #2 on: August 18, 2014, 08:49:38 AM »

Pittards leather is much too soft for straps. Veg tanned goat is probably the best to look for.  Veg tanning produces a stiffish not stretchy leather and goat may be thin enough and is very tough. You would need to stain it to your preferred colour. It does not have to be grey. Black or maroon, to match the edging of the case is a good choice.
« Last Edit: August 18, 2014, 08:51:46 AM by Theo »
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Nick Collis Bird

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3785
  • Been squeezing melodeons for over 48 years (badly)
Re: Replacing worn straps on Liliput
« Reply #3 on: August 18, 2014, 09:12:22 AM »

As above, and as usual I agree with Theo. Don't despair too quickly though. My Lilliput 1930's something still has its original grey straps and they are becoming furry, but just because the top finish is wearing, you will be amazed  at how strong it still is.
 Cheap leather belts and a scalpel could be your answer and CGM will certainly have something to suit.
Logged
Has anyone heard of the song. “ Broken Alarm-clock Blues” ? It starts   â€œI woke up this Afternoon”

malcolmbebb

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2628
  • In dampest Dorset, on the soggy south coast.
Re: Replacing worn straps on Liliput
« Reply #4 on: August 18, 2014, 09:19:54 AM »

Pete Dunk (I think) has a Liliput with dark red/maroon trim and straps dyed to match. It looks really good in the photos I've seen.
Charlie sells straps, including Velcro bass straps, although I think Pete's come from Theo.

Logged
Dino BPII.
"Tradition is not the worship of ashes, but the preservation of fire."

Prestidigitator

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 448
  • Saltarelle, Hohner, Oakwood Baffetti
Re: Replacing worn straps on Liliput
« Reply #5 on: August 18, 2014, 11:51:18 AM »

If you want to stay with plain, unpadded shoulder straps, Charlie Marshall does a leather single strap (0035 or extra long 003XL) in red, black and natural. Assuming these are still the same spec (main strap a shade under 20mm wide, and the narrower ends 15mm), I have one on my Hohner 114C ring fitting, and a quick swap-over shows it fits and looks OK on my Liliputs. One has a V-bar strap fitting and the other the post and D-ring type.

The bass strap looks as if it might be a bit more complicated, when it comes to maintaining adjustability.

Charlie does a plain leather 30mm wide bass strap in various colours (but oddly, not apparently natural, so dyeing a problem unless you buy the 39mm wide version, which does come in natural and would need narrowing a lot). These are a bit wider than the grey strap by about 2mm and some width adaptation for the buckle would be needed. However, if they are still the same as ones I have used on other Presswood Hohners, the leather of these is thicker than the grey strap (about 2.75mm against approximately 1.5mm on both my Liliputs). 

He also sells a Hohner plain bass strap in black only, which is 34mm wide. The bass straps on my German-made Ericas are about 2.25mm thick.

The side bars on the Liliput bass strap adjusting buckle are close to the central one, and, on mine, a tight fit using the quite thin grey straps. I suspect that it would not be possible to use it with a thicker strap, unless some serious thinning (and likely weakening) of the leather at the ends was undertaken, perhaps by scraping or hammering; or you could use a larger buckle. Leather thickness may also be a consideration in the plate and screw fittings to the bass end (perhaps requiring very slightly longer screws for adequate grip). I'd seek some information and advice from Charlie, especially regarding thickness.

If you can source some suitable leather of the right thickness as Theo suggests, and can do (or have done) the necessary buckle and other riveting, then you'd be able to reproduce exactly the grey straps (shoulder and bass) and colour them as you wish.

A "ready-made straps" solution, in red, black or dyeable "natural",  is possible, but I think you might have to change the bass strap type/adjustment method, and perhaps the strap-to-box screws. 


Logged

Matthew B

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 894
Re: Replacing worn straps on Liliput
« Reply #6 on: August 18, 2014, 03:06:01 PM »

Thanks folks, that gives me plenty to go on.  Despite being very worn looking the straps have all held together very well so far.  However I fear a catastrophic failure which will doubtless happen mid-session and over a hard surface. 

Charlie has already responded with a highly informative email and I may also go and have a chat with a local leather-worker.  Earlier today I spotted the premises of "Wm E. Scott & Son Sporran Makers and Highland Belts".  How could I possibly resist that opportunity?
Logged
Charter Member Presumpscot and Fore River Accordion Club

Nick Collis Bird

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3785
  • Been squeezing melodeons for over 48 years (badly)
Re: Replacing worn straps on Liliput
« Reply #7 on: August 18, 2014, 03:15:37 PM »

Ah! It's the sporran that worries me.
Logged
Has anyone heard of the song. “ Broken Alarm-clock Blues” ? It starts   â€œI woke up this Afternoon”

brianread

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1012
    • Slow and Steady Session in West Lancashire/Greater Manchester; Dance club in Rainford
Re: Replacing worn straps on Liliput
« Reply #8 on: August 18, 2014, 07:52:39 PM »

Here's a picture of my liliput with a mally strap and CGM velcro adjustable bass strap and popper bellows strap. The top strap bracket is also new as it broke! (also came from CGM).

Logged
Brian Read
D/G Oakwood (new model), D/G, C /F, Bb/Eb and E/A Liliputs,
A STREB!!,
2.5 D/G Self made Emmanuel Pariselle, D/G Pokerwork,
and Wolverton Advanced G/D Anglo Concertina and C/G  1937 Wheatstone.
all played "lefty" with mostly an extra air button, except the Concertinas which I play the conventional way round.

Pete Dunk

  • Typo Expert
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3706
Re: Replacing worn straps on Liliput
« Reply #9 on: August 18, 2014, 08:34:04 PM »

Pete Dunk (I think) has a Liliput with dark red/maroon trim and straps dyed to match. It looks really good in the photos I've seen.
Charlie sells straps, including Velcro bass straps, although I think Pete's come from Theo.

My straps were originally light tan plain leather which were supplied and dyed maroon by Theo. The bass strap is a Costalottie style velcro adjustable type with orange corduroy padding that looks really nice but it does mean you'll never be able to stand the box up on it's bass end again without ludicrously large feet. The bellows straps were changed for a press stud type also dyed maroon, I think it's quite pretty!  Here 't'is.




Logged
Squeezing on the Isle of Oxney, UK
Primo (Serenellini) D/G
Isis D/G
Hohner B/E, G/C, C/F, Bb/Eb G/C/F
Liliputs D/G (G scale), C/F, Bb/Eb, Albrecht Custom D/G (G scale)

Broadland Boy

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1243
  • Awful noises from Pokerwork, HA114G, BbEb Liliputs
Re: Replacing worn straps on Liliput
« Reply #10 on: August 18, 2014, 10:41:05 PM »

My (original grey) bass end strap had almost gone through at the box corners and bar on the adjuster on receipt, after feeding it and the shoulder straps with some neatsfoot oil based leather dressing (do not let this near the grille until well dried as it turns the plating green !) this removed the 'fluffing' and some longwise zigzag stitching over the weak bits on the sewing machine has given back full strength and my confidence, with hindsight I should perhaps have looked for some grey thread but the ancient black waxed stuff I use can tow start tractors ;D
Logged
Richard A
Venit ventus contrarius ventus egrediente,
Omnes prope quid ventum est circa
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal