Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Trouble getting reed block out of new Erica  (Read 1328 times)

0 Members and 1 Guest are viewing this topic.

Paul Young

  • Good talker
  • **
  • Offline Offline
  • Posts: 72
    • paulyoungfolk.co.uk
Trouble getting reed block out of new Erica
« on: November 24, 2014, 09:49:41 AM »

Is there any trick to getting the bass end reed blocks out on new Ericas? I was trying to get one out recently (to take out the thirds) but found that after I'd unscrewed the little bracket thing the reed block would slide back and forth a little, but not enough to release it from the wooden bits holding it at either end.

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Trouble getting reed block out of new Erica
« Reply #1 on: November 24, 2014, 10:41:53 AM »

It should lift up at the end with the screwed bracket.   Probably just a tight fit.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Malcolm Clapp

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1119
  • Loving my Hohner-reeded wet MMM CastaTommy
Re: Trouble getting reed block out of new Erica
« Reply #2 on: November 24, 2014, 11:16:30 AM »

Remove the (bigger) bass note reed-block first, then the chord block, as the rivets holding the bass reeds to their plates can catch on the edge of the chord reed-block fondo.
Sometimes it is necessary to remove both reed blocks simultaneously as a glue or (more likely) wax over-run can cause the two blocks to bind..
Worth a try anyway.
Good luck.
Logged
Tuner/repairer, now retired.

Paul Young

  • Good talker
  • **
  • Offline Offline
  • Posts: 72
    • paulyoungfolk.co.uk
Re: Trouble getting reed block out of new Erica
« Reply #3 on: November 24, 2014, 09:00:37 PM »

Got it out in the end. Just required a bit more brute force than I'd been prepared to employ last time (not my box). Very loud cracking sound as it came out which had me worried for a moment - possibly a bit of stray glue or wax as Malcolm suggested as it went back in fine and then came out more easily the second time. Thanks.
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal