Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: live sound: tricks to modify the tone of the box  (Read 1449 times)

0 Members and 1 Guest are viewing this topic.

Vector

  • Good talker
  • **
  • Offline Offline
  • Posts: 70
live sound: tricks to modify the tone of the box
« on: December 13, 2014, 05:17:57 PM »

Hi Everyone - I have recently had a few opportunities to play through a sound system. I am interested in learning how I control or modify the sound of my box as it is coming through the sound system. Using the mixing board on a PA system, is it possible to modify the tone of the box?

I would like to try to make my sound a bit warmer - I have a very dry box, so it sounds somewhat nasal, thin and metallic coming through PA speakers. How could I warm up my sound to sound more like I normally sound when I'm not on mic?

I like my sound normally but when I'm on mic I'm always shocked at how cold and dry I sound - is there a way I can warm up my sound through the mixer?

Any thoughts on this?
Logged
chasing the tunes

squeezy

  • Quick starter (now lagging behind)
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1317
  • Hohner Cornelia (mixte D/G/o&s)
    • www.johnspiers.co.uk
Re: live sound: tricks to modify the tone of the box
« Reply #1 on: December 13, 2014, 09:50:01 PM »

Depending on the complexity of the mixer there are different degrees of control you have on the sound of the box - but usually you should have quite a bit of control.

Before going in to too much detail ... the quality of microphone you are using will normally make more difference to the sound than any amount of knob-twiddling.  If you like the sound of your box, but do not like it when it's amplified then the likely culprit is the microphones (and to some extent their placement too - you hear your box from several feet away when playing acoustically - it's not surprising that a microphone an inch away from the box sounds different)

Nasal, thin and metallic suggest you're getting a lot of high-mid to high frequencies through the mic.  Your PA's mixer should have a series of EQ filters on each channel strip ... normally at least a high frequency, mid frequency and low frequency knob (that's treble, mid and bass to most people).  The first thing I'd try with your symptoms is to turn the treble down a touch which will take any harsh edge off the sound.  My hunch is that if you turn the mid range up you'll only increase the nasal element - but experiment with that too.  For the right hand of a melodeon - turning the bass up might increase the warmth a tiny bit - but normally all that happens is that it amplifies any button noise in to a huge thud!

Sometimes you'll have another button which changes the mid-centre (very useful!) - effectively what that does is defines the frequency range the mid knob is changing.  So if you have it set to it's highest frequency it will make the mid knob turn the kind of annoying nasal "telephone voice" frequencies up and down - while it leaves the deeper, warmer mid frequencies alone.

Don't be scared to have a bit of a play around ... trial and error normally gives the best results!

good luck!
Logged
Squeezy

Sometimes wrong, sometimes right ... but always certain!

Paul Crook

  • Member
  • *
  • Offline Offline
  • Posts: 10
  • D/G Erica, Shelburne Falls, MA, USA
Re: live sound: tricks to modify the tone of the box
« Reply #2 on: December 13, 2014, 10:51:35 PM »

Squeezy's advice is spot-on.

I've handled live sound for my own band and several others over the past 20 years. The best collection of wisdom that I've found is the booklet All Mixed Up by Bob Mills, available for free at http://www.bobmills.org/amu/

For the specific problem of nasal sound:
If you've got the knob Squeezy mentions that changes the midrange frequency, try turning the midrange up (say, halfway above zero). Have a helper sweep slowly through the frequency range while you play. When you hear the annoying nasal sound get even more annoying; this indicates that you've found one of the ranges that's doing you harm. Now have your helper turn down the midrange (below zero) until the sound improves without sounding hollow. I find this easier than trying to adjust the midrange frequency and midrange cut at the same time.
Logged

Vector

  • Good talker
  • **
  • Offline Offline
  • Posts: 70
Re: live sound: tricks to modify the tone of the box
« Reply #3 on: December 13, 2014, 11:56:14 PM »

Thanks for your insight guys!
I did some experimentation today and found that I was getting too close to the mic - I also looked into turning down some of the highs and mids - I was trying to warm the sound up by increasing the lows but that just made me sound muddy -

With the sm58 I need to get too close, so I think I'll stick with the sm57

Thanks again!
Logged
chasing the tunes
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal