Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Convert cf to dg  (Read 4627 times)

0 Members and 1 Guest are viewing this topic.

Rog

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2525
  • Repair and tuning in Hants
Convert cf to dg
« on: April 22, 2015, 12:04:11 PM »

Hi,
There is an old thread that sort of covers this, but not in any particular detail (the general advice seemed to be to buy some new reeds). If I want to convert a standard two row CF box to DG, with minimal reed purchases, and with retuning within technically feasible parameters, or using some reeds from, say, a PA, what is the best way to do it?
Cue, Theo, who may be an expert on this... (:)

Lester

  • MADman
  • Mods and volunteers
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 9327
  • Hohners'R'me
    • Lester's Melodeon Emporium and Tune-a-Rama
Re: Convert cf to dg
« Reply #1 on: April 22, 2015, 12:39:27 PM »

Next week I shall be doing this exact thing. Somewhere I have a spreadsheet that does which reeds go where to minimise hard stuff. As your starter for ten is best to go to fourth button start for the D/G.

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Convert cf to dg
« Reply #2 on: April 22, 2015, 01:10:47 PM »

I don't think I can put all the things I have learned about this task into a post here, it would take too long.   But my basic approach is to make a list of all the reeds in the donor box in order of pitch, make a second list of the reeds required for the new layout, also in order of pitch, then put the two lists together so as to minimise the amount of re-tuning.  Its all about learning how much pitch you can shift a reed by, and that is something that you have to learn by trial and error.  I still have the first box I converted and although it has all the right notes in the right places it is a dog!  I keep it as a useful reminder of my limitations.

Looking at boxes that others have converted will give you ideas, including things NOT to do.  The worst two botches I've seen are: (1) reeds with the tip clipped off to raise the pitch, and the gap closed with masking tape, and (2) dollops of solder applied to the middle of the reed to lower the pitch.  Both are a disaster in terms of reed performance, but I have seen both in "restored" boxes that people paid good money for.



Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Convert cf to dg
« Reply #3 on: April 22, 2015, 01:40:13 PM »

Picture of clipped reed.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Rog

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2525
  • Repair and tuning in Hants
Re: Convert cf to dg
« Reply #4 on: April 22, 2015, 01:48:26 PM »

(:). It's not very pretty

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Convert cf to dg
« Reply #5 on: April 22, 2015, 01:55:36 PM »

It makes me cross that such poor workmanship can be sold to unsuspecting players.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

rees

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 5055
  • Windjammer
    • Wesson Accordions
Re: Convert cf to dg
« Reply #6 on: April 22, 2015, 08:27:25 PM »

Ghastly behaviour  >:(
Logged
Rees Wesson (accordion builder and mechanic)
Gungrog, Welshpool, Wales, UK
www.melodeons.com

tirpous

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1403
Re: Convert cf to dg
« Reply #7 on: April 23, 2015, 09:36:20 PM »

Would the clipped reed be more acceptable if the slot was shortened to fit the new reed length, using some kind of solid filler ?
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Convert cf to dg
« Reply #8 on: April 23, 2015, 09:57:34 PM »

You could try it and let us know how you get on! 
It's quite unnecessary to go in for such drastic reed surgery if you understand how reeds work and how they can be tuned up or down. I've done quite a few conversions from CF or BbEb to DG and it's just not necessary to treat reeds so brutally.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

baz parkes

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1894
    • All Blacked Up
Re: Convert cf to dg
« Reply #9 on: April 29, 2015, 09:46:31 AM »

it's just not necessary to treat reeds so brutally.
I've been in several sessions where I've thought much the same thing.... :|glug
Logged
On the edge of Cheshire's Golden Triangle, apparently...

Rog

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2525
  • Repair and tuning in Hants
Re: Convert cf to dg
« Reply #10 on: May 08, 2015, 08:06:25 PM »

In the case of a Liliput conversion, if you need replacement reeds here and there, what do you do? They seem to me narrower and smaller than standard Hohner reed plates. I've just declubbed a Liliput and managed with all the original reeds. It crossed my mind that I might have to grind down the edges of a donor reed plate if I happened to need one. Luckily I didn't. In the case of altering the pitch there is always the possibility of it going wrong and one needing a replacement...which might be difficult with a Liliput...

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Convert cf to dg
« Reply #11 on: May 08, 2015, 08:13:18 PM »

Yes Lilliput reeds need to be carefully conserved.  Not only are the reed plates narrower, but the scale length is shorter, that is the reed tongues are shorter for a given pitch. 
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Rog

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2525
  • Repair and tuning in Hants
Re: Convert cf to dg
« Reply #12 on: May 08, 2015, 08:49:28 PM »

Thanks Theo. I'm going to try a CF to DG conversion... But not on a Liliput (:).  Is it possible to do this with just the CF reeds ....or are there some critical reeds that can't be converted from the CF set?  This is relevant in the case of a Liliput because of their unusual specification. ...
Mod...though i think the bass reeds in my Liliput  were the same size as those found in a Hohner student III pa.
« Last Edit: May 08, 2015, 08:51:42 PM by RogerThomas »
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Convert cf to dg
« Reply #13 on: May 08, 2015, 08:56:05 PM »

Yes, I eventually found it is possible with a two row, or with a club layout. It's not easy so don't be surprised if your first attempt leaves room for improvement.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

tom f

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 112
Re: Convert cf to dg
« Reply #14 on: May 09, 2015, 08:31:15 PM »

In the case of a Liliput conversion, if you need replacement reeds here and there, what do you do? They seem to me narrower and smaller than standard Hohner reed plates. I've just declubbed a Liliput and managed with all the original reeds. It crossed my mind that I might have to grind down the edges of a donor reed plate if I happened to need one. Luckily I didn't. In the case of altering the pitch there is always the possibility of it going wrong and one needing a replacement...which might be difficult with a Liliput...

I think some of the early mark Hohner Imperial PAs have the same size reeds as the Liliput and can be bought quite cheaply on Ebay.de
Logged

Chris Ryall

  • "doc 3-row"
  • French Interpreter
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 11154
  • Wirral UK
    • Chris Ryall
Re: Convert cf to dg
« Reply #15 on: May 10, 2015, 07:26:41 AM »

Am I being stupid? I have retuned the odd note, but to shift/tune two entire rows seems to me a lot of work for the return involved. There is is fairly healthy, and fluid market in melodeons (notably here) with D/G's readily available; while C/Fs … are fungible enough?

So my instinct might be to sell and buy, unless the box had belonged to Grandad. :|glug

[ed] The "Aire Geste" DVD I've just helped subtitle finishes with a Stef/Nono interview, in which organology is discussed. They both play C/Fs on gigs, but "see" those as D instruments! Though I guess the only UK session tunes those guys play might be Jump at the Sun
« Last Edit: May 10, 2015, 07:35:13 AM by Chris Ryall »
Logged
  _       _    _      _ 

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Convert cf to dg
« Reply #16 on: May 10, 2015, 08:47:52 AM »

Chris, you are quite correct, conversion from one key to another is expensive in time and labour and in most cases not worthwhile.  It's only worth considering if the box in question is not made in the desired key, eg an old Hohner Club, Lilliput etc.  The full size boxes like the Erika can be converted most effectively with a set of new reeds, but the likes of the Lilliput uses smaller that standard size reeds, which are not obtainable new.
« Last Edit: May 10, 2015, 08:49:55 AM by Theo »
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Chris Ryall

  • "doc 3-row"
  • French Interpreter
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 11154
  • Wirral UK
    • Chris Ryall
Re: Convert cf to dg
« Reply #17 on: May 10, 2015, 10:02:28 AM »

Just to say that Theo has flipped plates for me, and shifted an accidental that came from its maker  in the wrong octave.

Biggest project so far was converting a Lilly (single voice) to 4th start and club, but I think even that was just 2 extra plates and a retune of one other?,

An experimental "blues box" is yet to come, but that involves a carcass, true surgery, (221 tuning, all the way up) … and the quote was quite a bit more ::)
Logged
  _       _    _      _ 

Kimric Smythe

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 712
    • Smythe's Accordion Center
Re: Convert cf to dg
« Reply #18 on: May 13, 2015, 05:12:17 PM »

As a related note, if you are looking for narrow reed plates for a liliput , the super compact 120 bass LIRA accordions have special plates that are about 20 % narrower than anything else I have seen. These were student accordions from the 50's.
Logged
Smythe's Accordion Center
Pinole, California
Sales and repairs since 1997
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal